Laser welding is used in critical component production when tight tolerances like minimal distortions and residual stresses are required. Laser beam welding offers a lower heat input, a smaller heat affected zone, lower residual stresses, minimum distortions, and greater mechanical joint characteristics than conventional welding does. In order to simulate the laser welding process used on SS316L plates, the Gaussian heat source model was used. The model is developed and simulated with volumetric heat source model with APDL coding using ANSYS. The thermal profiles at the joint cross sections via welded area, interface across joints is taken for the analysis. The maximum temperature was observed at the fusion zone and associated zones. The residual stresses are analysed in the same path and found the stresses are in safe limits of base material. Predicted and experimentally measured residual stresses are close agreement with 10%.
2 January 2023 in International Journal on Interactive Design and Manufacturing (IJIDeM)
In this work, simulation has been carried out for multipass Gas tungsten Arc Welding of SS316L and their effects were studied for thermal, and residual stresses and compared with experimental results. The sequentially coupled thermo-mechanical, transient thermal and static structural analysis was modelled using ANSYS with relevant Ansys Parametric Design Language coding. Infrared thermography camera was used to obtain the real time temperatures during the welding. The effect of temperatures and the induced residual stresses of the weldment is measured with X-Ray diffraction technique. Tensile residual stresses have been identified at fusion zone and compressive stresses at heat affected zone. Pass wise temperature measurements were taken from analysis and experiment the agreement with 7.24%. The agreement of measured and analysed residual stress had an agreement with 16.66%.
In the frame of the circular economy, welding of Ni-based superalloys has gained increasing importance when applied, for instance, to repairing highly expensive components widely used in strategical sectors, such as the defense and aerospace industries. However, correct process parameters avoiding metallurgical defects and premature failures need to be known. To reach this goal, Inconel 625 butt-welded joints were produced by CO2 laser beam welding and different combinations of process parameters. The experimental investigation was carried out with three parameters in two levels with an L4 orthogonal array. Laser power, welding speed, and shielding gas flow rate were varied, and the results were reported in terms of mechanical properties, such as microhardness, tensile strength, distortion, residual stress, and weld bead geometry, and metallurgy. At a lower welding speed of 1 m/min, the full penetration was observed for 3.0 kW and 3.3 kW laser powers. However, sound welds (porosity-free) were produced with a laser power of 3.3 kW. Overall, the obtained full-penetration specimens showed a tensile strength comparable with that of the parent material with residual stresses and distortions increasing with the increase in heat input.