The method of obtaining functional materials almost always influences the physicochemical properties of the resulting substances. The plasma treatment of solid materials is considered to be a more energy efficient method when compared with thermal destruction. Our work is the first to treat double complex salt (DCS) [Co(NH3)6][Fe(CN)6] with different plasma discharge modes. We have demonstrated the possibility of obtaining a single-phase spinel with a CoFe2O4 structure as a result of the calcination in air of the plasma destruction product. The crystallite sizes of the obtained spinel are 40 nm, with a lattice constant 8.38 Å.
Double complex salts (DCSs) of the composition [Co(NH3)6][Fe(CN)6] are a promising precursor for the preparation of catalysts for the hydrogenation of carbon oxides (CO and CO2) by Fischer–Tropsch synthesis. The specific surface area is an important parameter for catalysts. Our article investigates the influence of mechanochemical activation (MCA) on this DCS in order to determine the conditions for obtaining the largest specific surface area of the intermetallic compound, a product of the DCS thermolysis. In this work, the effect of MCA on the physicochemical properties of the DCS [Co(NH3)6][Fe(CN)6] and the products of its thermal decomposition in an argon atmosphere were investigated. It was shown that MCA leads to partial reduction of Fe+3 to Fe+2, changes in the coordination of ammonia, amorphization of the structure and a decrease in the thermal stability of DCS. Thermolysis at 650 °C of samples subjected to MCA for 10 min results in the formation of nanocrystalline intermetallic compound Co0.5Fe0.5. The results demonstrate the potential of using MCA to control the properties of functional materials based on DCS.
20 December 2023 in Transactions of the Kоla Science Centre of RAS. Series: Engineering Sciences
ISI.V. Tananaev Institute of Chemistry and Technology of Rare Elements and Mineral Raw Materials of the Kola Science Centre of the Russian Academy of Sciences
I.V. Tananaev Institute of Chemistry and Technology of Rare Elements and Mineral Raw Materials of the Kola Science Centre of the Russian Academy of Sciences
The paper presents the first comparative study of the microstructure and mechanical properties of gadolinium zirconate ceramics produced by spark plasma sintering of powders obtained using hydroxide precursors synthesized with and without mechanical activation. The initial precursor was prepared via reverse coprecipitation of hydroxides. Mechanical activation of the precursor was performed in an AGO-2 planetary mill at a centrifugal acceleration of 20 g for 30 min. X-ray phase analysis revealed that the resulting ceramics were nanocrystalline. The ceramics produced from the mechanically activated precursor demonstrated superior mechanical properties, including higher microhardness and Young’s modulus, compared to those produced from the non-activated precursor.