Nickel-rich layered transition metal oxides (LiNixMnyCo1−x−yO2 (x ≥ 0.6), Ni-rich NMCs) have been under intense investigation as high-energy density and low-cost positive electrode materials for Li-ion batteries. However, insufficient cyclic and thermal stability as well as low tap density hinder broad commercial application of commonly used polycrystalline Ni-rich NMCs. Here, we report on single crystal Ni-rich NMCs with improved cycling stability and ultra-high tap density up to 3.0 g cm−3 coupled with high discharge capacity, resulting in enhanced volumetric energy density of prepared electrodes up to 2680 W h L−1. Record tap density is achieved due to the formation of single crystal particles with spherical-like shapes through adjustment of the lithium chemical potential by using K2SO4 as a solvent during the single crystal growth. The designed single crystal NMC622 and NMC811 cathode materials are promising for applications in batteries with high specific energy and long-term cycling life.
3 June 2024 in Journal of the Electrochemical Society
With sodium-ion batteries (SIBs) finding widespread application, the demand grows for hard carbon, the most popular anode material for SIBs. Hydrothermal carbonization facilitates the production of hard carbon with desired characteristics from various sources. Despite the considerable volume of literature addressing this subject, there is a notable absence of investigations elucidating the relationship between synthesis conditions and the electrochemical characteristics of the product. Here we study systematically the influence of hydrothermal carbonization parameters on hard carbon characteristics and emphasize the potential of hard carbon as an anode material for SIBs. The initial Coulombic efficiency (ICE) is significantly affected by the particle size of the glucose-derived hard carbon, which, in turn, depends on glucose concentration in the initial solution, pH, and stirring regime. By optimizing the hydrothermal carbonization parameters, the ICE up to 91% and a good reversible capacity of ∼300 mAh g−1 in a half cell are achieved. Full cells with Na3(VO)2(PO4)2F cathode material demonstrate ICE of about 80% and reversible capacity of up to 100 mAh g−1cath. Considering the effective performance of pouch-cell SIB prototypes based on Na3(VO)2(PO4)2F and hard carbon, hydrothermal carbonization of glucose yields hard carbon with the necessary characteristics required for its successful application in SIBs.
Ni-rich layered transition metal (TM) oxides are considered to be the most promising cathode materials for lithium-ion batteries because of their high electrochemical capacity, high Li+ ion (de)intercalation potential, and low cobalt content. However, such materials possess several drawbacks including relatively low volumetric energy density caused by insufficient values of tap density. Herein, we demonstrate an exceptionally rapid and energy-saving synthesis of the mixed hydroxide precursor for the LiNi0.8Mn0.1Co0.1O2 (NMC811) positive electrode (cathode) material through a microwave-assisted hydrothermal technique. The obtained material further serves as a space-filler to fill the voids between spherical agglomerates in the cathode powder prepared via a conventional co-precipitation technique boosting the tap density of the resulting mixed NMC811 by 30% up to 2.9 g/cm3. Owing to increased tap density, the volumetric energy density of the composite cathode exceeds 2100 mWh/cm3 vs. 1690 mWh/cm3 for co-precipitated samples. The crystal structure of the obtained materials was scrutinized by powder X-ray diffraction and high angle annular dark-field scanning transmission electron microscopy (HAADF-STEM); the cation composition and homogeneity of TM spatial distribution were investigated using energy-dispersive X-ray spectroscopy in a STEM mode (STEM-EDX). Well-crystallized NMC811 with a relatively low degree of anti-site disorder and homogeneous TM distribution in a combination with the co-precipitated material delivers a reversible discharge capacity as high as ~200 mAh/g at 0.1C current density and capacity retention of 78% after 300 charge/discharge cycles (current density 1C) within the voltage region of 2.7–4.3 V vs. Li/Li+.
We have studied the redox sorption of oxygen from flowing distilled water in a multistage sorptionmembrane cell with a metal (Cu)–sulfo cation exchanger (KU-23 in the H+form) granular nanocomposite...
30 December 2011 in Russian Journal of Physical Chemistry A
The kinetics of the reduction of oxygen on a granular copper-containing electron-ion exchanger, or a nanocomposite consisting of an ion-exchanging resin matrix and a nanodispersed copper bulk...
13 May 2011 in Russian Journal of Physical Chemistry A
The formation of copper nanoparticles in a KU-23 15/100 sulfocation-exchanger was studied. It was demonstrated that the formation of copper as assemblies from nanoparticles with sizes of 3 to 10 nm...