A medium-chain triglyceride (MCT) oil microcapsule was prepared by spray drying. The effects of the wall-material parameters of wall-to-oil ratio (1:1 to 3:1) and type of wall material (gum arabic (GA), whey protein isolate (WPI), and octenyl succinic anhydride (OSA) starch) on the microcapsules were evaluated. The droplet size, size distribution, viscosity, zeta potential, and stability of the emulsions were measured. The spray-dried powder was characterized by its morphology, yield, encapsulation efficiency, and moisture content. The wall material influenced the characteristics of the emulsions and microcapsules. The formulation with a 2:1 wall-to-oil ratio and OSA starch/maltodextrin as the wall material resulted in a small droplet size (0.177 ± 0.002 µm) with high encapsulation efficiency (98.38 ± 0.01%). This formulation had good physical stability over three months under accelerated conditions. Thus, OSA starch/maltodextrin is an appropriate wall material for encapsulating MCT oil.

Organic solvents are commonly used to extract lutein. However, they are toxic and are not environmental-friendly. There are only a few reports on the quantification of lutein. Therefore, this study aimed to determine a suitable extraction method by which to obtain lutein from marigold flower (Tagetes erecta L.), using coconut oil to evaluate the cytotoxicity of extract in ARPE-19 cells, to optimize the encapsulation process for the development of microencapsulated marigold flower extract, and to develop the method for analysis of lutein by using UHPLC-Q-Orbitrap-HRMS. Coconut oil was used for the extraction of marigold flowers with two different extraction methods: ultrasonication and microwave-assisted extraction. The UHPLC-Q-Orbitrap-HRMS condition for the analysis of lutein was successfully developed and validated. Marigold flower extract obtained using the microwave method had the highest lutein content of 27.22 ± 1.17 mg/g. A cytotoxicity study revealed that 16 µM of lutein from marigold extract was non-toxic to ARPE-19 cells. For the development of microencapsulated marigold extract, the ratio of oil to wall at 1:5 had the highest encapsulation efficiency and the highest lutein content. Extraction of lutein using coconut oil and the microwave method was the suitable method. The microencapsulated marigold extract can be applied for the development of functional ingredients.

Non-destructive analysis of chlorpheniramine maleate (CPM), pharmaceutical tablets, and granules was conducted by chemometrics-assisted attenuated total reflectance infrared spectroscopy (ATR-IR). For tablets, an optimum PLSR model with eight latent factors was obtained from area-normalized and standard normal variate (SNV) pretreated ATR-IR spectral data with correlation coefficients (R²) of calibration and cross-validation of 0.9716 and 0.9602, respectively. The model capability for the 42 test set samples was proven with R² between the reference and model prediction values of 0.9632, and a root-mean-square error of prediction (RMSEP) of 1.7786. The successive PLSR model for granules was constructed from SNV and first derivative pretreated ATR-IR spectral data with two latent factors and correlation coefficients (R²) of calibration and cross-validation of 0.9577 and 0.9450, respectively.