Hydrothermal liquefaction (HTL) of microalgae Nannochloropsis (NAS) over various transition metal M/TiO2 (M = Fe, Co, Ni, Mo, and Mn) was investigated. Ni/TiO2 was the most effective catalyst to improve the yield and quality of biocrude and the liquefaction conversion. Ni/TiO2 was characterized by XRD, XRF, and XPS. The research of Effect of reaction temperature on HTL of NAS over Ni/TiO2 suggested that 300 °C led to a maximum biocrude yield of 48.23% and the highest liquefaction conversion of 89.28%. Adding Ni/TiO2 catalyst reduced the viscosity and provided more light-fraction in biocrude while brought a slight increase in total acid number (TAN). Gas chromatography-mass spectrometry (GC-MS) analysis demonstrated that adding Ni/TiO2 considerably changed the composition of biocrude and the possible pathways were discussed. Reproduction test showed the Ni/TiO2 has an excellent reproduction ability in HTL of NAS.
Catalytic liquefaction of (Municipal sewage sludge) MSS over transition metal catalysts in ethanol-water co-solvent (EWCS) was investigated. The effect of operating parameters like temperature, holding time, and ethanol-water ratio was discussed. CuSO4 was selected as the most efficient catalyst. The highest biocrude yield (47.45%) and liquefaction conversion (97.74%) was both obtained at the same conditions following: a reaction temperature of 270°C, a holding time of 30min, an ethanol-water ratio of 1:1, and with CuSO4 as the catalyst. Optimized operating conditions reduced Sulfur and Nitrogen content in biocrude by 55.0% and 14.6%, respectively. The obtained biocrude samples were analyzed and characterized by thermogravimetric analysis (TGA) and gas chromatography-mass spectroscopy (GC-MS), which suggested that adding CuSO4 increased the light-oil like content in biocrude and more than 60% of compounds in biocrude were esters. This process demonstrates the effectiveness of catalytic liquefaction of MSS in EWCS over CuSO4 catalyst.
• Catalytic liquefaction could convert 89.77% of human feces. • The highest biocrude yield was 53.16% with Ni-Tm/TiO2 catalyst. • Catalyst, temperautre and time significantly influenced the biocrude composition. • The distribution of gaseous products at different HTL conditions were analyzed.
Hydrothermal liquefaction (HTL) is a promising method to convert wet microalgae into a petroleum-like biocrude. In this paper, we demonstrated the HTL of microalgae Spirulina over various clay material catalysts and open up interesting perspectives for efficiently liquefaction processes. The clay catalyst successfully improved the biocrude yield, the liquefaction conversion, and energy recovery. Investigation into optimizing operation conditions suggested that the reaction temperature and holding time significantly influenced the HTL process. The highest biocrude yields were obtained at a reaction temperature within the range of 220–250 °C and a holding time of 30 min with montmorillonite (46.56%), kaolinite (44.07%) and dolomitic limestone (46.35%). Adding clay catalysts changed the element content and produced more asphaltene content in the biocrude. The GC-MS analysis revealed that the catalyst greatly influenced the composition of the hydrocarbons, acids, esters, amides and heterocyclic compounds in the biocrude.