The interface defeat and dwell can effectively improve the ballistic performance of ceramic armors under high velocity impact of long rod projectiles. Confinement conditions along both axial and radial directions of ceramic armors can affect these behaviors. With the aim of giving an insight into the effect of cover plate thickness and connection mode of cover plates with confining tubes on these behaviors, numerical simulations were performed in which the confined silicon carbide (SiC) targets with cover plates were impacted by tungsten rods. The pressure on the surfaces of SiC targets with fixed cover plates are compared to that with free cover plates, showing that the plates fixed with the confining tubes can produce higher pressure by way of wedging. With the increase in cover plate thickness, the dwell duration of the tungsten rods on the ceramic interface gradually grows. In addition, the upper and lower limits of transition impact velocities for the SiC targets with cover plates in different connection modes (i.e., free or fixed) were obtained and analyzed. The results show that the increase rate of the transition velocity region for the cover plate with the fixed-mode is relatively stable and lower than with the free-mode. On this basis, the fixed cover plate contributes higher ballistic performances to the SiC target than the free cover plate. It is also noteworthy that the size of transition velocity region does not enlarge linearly with the increase in cover plate thickness due to the slow growth of the upper limit. Accordingly, thickness thresholds exist, which are 5 mm and 6 mm for the fixed and free cover plates, respectively. Considering the ballistic performance and economy, the cover plate with the thickness ranging from 3 mm to 5 mm, i.e., 1.5~2.5 times of the tungsten rod diameter, is ideal for the structural dimensions in this paper.
The Split Hopkinson pressure bar (SHPB) is widely used for characterizing the mechanical behavior of materials at high strain rates. One of the most challenging factors is achieving constant strain rate (CSR) loading of the specimen at a certain strain rate. Obtaining the effective incident pulse based on the experimental material for achieving CSR loading remains unresolved. This research focuses on obtaining the proper incident pulse for achieving constant strain rate loading using the pulse-shaping technique. A parameterized objective incident model in terms of the strain rate and quasi-static (or dynamic stress–strain) behavior of the material is established utilizing the three-wave method. Experimental pulses that closely resemble the desired objective pulses can be generated by adjusting parameters such as the geometry of the shaper, the shaper material, striker velocities, and the length of the striker according to the pulse-shaping model. The model is applied to the design of the incident pulse for B4CP/2024Al composite material, and the dynamic stress–strain curves at different strain rates are obtained under CSRs. This model provides effective guidance for selecting an appropriate shaper and achieving CSR loading in SHPB tests.