When the arch rib of the mid-bearing through and lower-bearing through arch bridges undergoes out-of-plane deformation, it is usually subject to the resilience force provided by the flexible hanger, which is known as the “non-conservative force effect” of the suspender. In contrast to the static condition, in the dynamic scenario, the time-varying non-conservative force exerted by the flexible suspender becomes more complex due to dynamic changes in external load. Moreover, the difference in fundamental frequency and vibration period between the bridge system and arch rib may influence the stress distribution within the arch rib during ground motion. This paper investigates the impact of time-varying non-conservative forces on the dynamic stability of arch ribs in concrete-filled steel tube (CFST) bridges under seismic loads. Specifically, it examines the influence of different seismic waveforms, frequency disparities between bridge slabs and arch ribs, and suspender stiffness on the non-conservative effect. The results reveal significant disparities in the impact of non-conservative forces exerted by the suspender during seismic events with identical intensity but varying frequency characteristics. The influence of non-conservative forces on the dynamic stability of bridges escalates as deck stiffness increases, while it remains relatively unaffected by changes in suspender stiffness.

Non-uniform temperature fields are developed during the welding of studs in steel–concrete composite bridges. Due to uneven thermal expansion and reversible solid-state phase transformations between ferrite/martensite and austenite structures within the materials, residual stresses are induced, which ultimately degrades the mechanical performance of the structure. For a better understanding of the influence on steel–concrete composite bridges’ structural behavior by residual stress, accurate simulation of the spatio-temporal temperature distribution during stud welding under practical engineering conditions is critical. This study introduces a precise simulation method for temperature evolution during stud welding, in which the Gaussian heat source model was applied. The simulated results were validated by real welding temperature fields measured by the infrared thermography technique. The maximum error between the measured and simulated peak temperatures was 5%, demonstrating good agreement between the measured and simulated temperature distributions. Sensitivity analyses on input current and plate thickness were conducted. The results showed a positive correlation between peak temperature and input current. With lower input current, flatter temperature gradients were observed in both the transverse and thickness directions of the steel plate. Additionally, plate thickness exhibited minimal influence on radial peak temperature, with a maximum observed difference of 130 °C. However, its effect on peak temperature in the thickness direction was significant, yielding a maximum difference of approximately 1000 °C. The thermal influence of group studs was also investigated in this study. The results demonstrated that welding a new stud adjacent to existing ones introduced only minor disturbances to the established temperature field. The maximum peak temperature difference before and after welding was approximately 100 °C.