Since the first report of 3D printed biodegradable structures by stereolithography, vat photopolymerization has shown great potential in the fabrication of medical implants and devices. Despite its superior printing quality and manufacturing speed, the development of biodegradable devices by this technique remains challenging. This results from the conflicting viscosity requirements for the printing resins, i.e., low viscosity is required for high‐resolution 3D printing, whereas high viscosity is often needed to provide high mechanical strength. Recently emerging photopolymerization‐based 3D printing techniques, including heat‐assisted digital light processing (DLP) and volumetric printing, have brought new hope to the field. With its tolerance to high viscosity resins, heat‐assisted DLP enables the fabrication of complex, personalizes architectures from biodegradable photopolymers that are not printable by conventional printing techniques. On the other hand, volumetric printing, which abandons the layer‐by‐layer printing principle and thus circumvents the dependence on low viscosity resins, could be highly beneficial for the 3D printing of biodegradable devices. This perspective evaluates the key challenges associated with biodegradable photopolymers used in the 3D printing of medical implants and devices. One focuses on their chemical structures and physical properties and discusses future directions offered by these emerging techniques.

An aqueous ratiometric ESIPT sensor with a 87 nM (15.4 ppb) detection limit was successfully synthesized and applied for detection of all oxidation states of palladium species.

3D printing has revolutionized the way of manufacturing with a huge impact on various fields, in particular biomedicine. Vat photopolymerization‐based 3D printing techniques such as stereolithography (SLA) and digital light processing (DLP) attract considerable attention owing to their superior print resolution, relatively high speed, low cost, and flexibility in resin material design. As one key element of the SLA/DLP resin, photoinitiators or photoinitiating systems have experienced significant development in recent years, in parallel with the exploration of 3D printing (macro)monomers. The design of new photoinitiating systems cannot only offer faster 3D printing speed and enable low‐energy visible light fabrication, but also can bring new functions to the 3D printed products and even generate new printing methods in combination with advanced optics. This review evaluates recent trends in the development and application of advanced photoinitiators and photoinitiating systems for vat photopolymerization 3D printing, with a wide range of small molecules, polymers, and nanoassemblies involved. Personal perspectives on the current limitations and future directions are eventually provided.

Customized bioresorbable airway stents with elasticity similar to silicone were 3D printed by digital light processing.

A brief summary of representative fluorescent chemosensors based on conjugated polymers with N-heterocyclic moieties, followed by a discussion on the limitations and challenges of current systems, as well as possible future research directions.

A colorimetric and ratiometric fluorescent chemosensor for F⁻ has been prepared, which is based on combination of desilylation reaction and excited-state proton transfer from the desilylation product to F⁻. The sensor exhibits rapid response, excellent selectivity and sensitivity to F⁻.