The motor characteristics control method using the winding changeover technique can improve the matching ratio between the most frequent operating point of electric vehicle (EV) and the motor’s high-efficiency operating point, thereby enhancing the overall average efficiency of the drive system. This technology reduces back electromotive force and winding resistance by adjusting the effective number of motor winding turns according to the EV’s operating speed, ultimately improving the average efficiency. In this paper, we propose a winding changeover circuit and control method that maximizes the average efficiency in the main driving regions to extend the driving range per charge and improve the fuel efficiency of EVs. The proposed circuit is constructed using thyristor switching devices, offering the advantage of relatively lower overall system losses compared to conventional circuits. Due to the characteristics of the thyristor switching devices used in the proposed circuit, seamless winding changeover is possible during motor operation. Additionally, no extra snubber circuits are required, and the relatively low switch losses suggest the potential for improved efficiency and lightweight design in EV drive systems. To verify the proposed winding changeover circuit and control scheme, experiments were conducted using a dynamometer with an 80 kW permanent magnet motor, inverter, and the developed prototype of the winding changeover circuit.
This study proposes a current control strategy to enhance the control stability of an interior permanent magnet synchronous motor (IPMSM) under transient conditions, such as rapid acceleration or deceleration in electric vehicle (EV) applications. Conventional current control methods provide optimal steady-state current references corresponding to torque commands using a lookup table (LUT)-based approach. However, during transitions between these reference points, particularly in the field-weakening region at high speeds, the voltage limit may be exceeded. When the voltage limit is exceeded, unstable overmodulation states may occur, degrading stability and resulting in overshoot of the inverter input current. Although ramp generators are commonly employed to interpolate between current references, a fixed ramp slope may fail to ensure a sufficient voltage margin during rapid transients. In this study, a method is proposed to dynamically adjust the rate of change of the d-axis current reference in real time based on the difference between the inverter output voltage and its voltage limit. By enabling timely field-weakening before rapid changes in speed or q-axis current, the proposed strategy maintains control stability within the voltage limit. The effectiveness of the proposed method was verified through simulations based on real vehicle driving profiles and dynamometer experiments using a 38 kW class IPMSM for a hybrid electric vehicle (HEV), demonstrating reduced input DC current overshoot, improved voltage stability, and enhanced torque tracking performance under high-speed transient conditions.