A method for estimating the two-dimensional (2-D) direction- and time-of-arrival of orthogonal frequency division multiplexing (OFDM) signals that utilizes only three antennas is proposed. It firstly constructs an array manifold matrix not only based on the symmetry of circular geometry but also the time diversity of every OFDM subcarrier, so that the array aperture can be greatly increased. It then proposes that a virtual spatial smoothing method be used to partition the array manifold matrix into structurally identical sub-array manifold matrix, so that coherent multipaths can be correctly estimated by incorporating the eigenstructure-based techniques on the average of the sub-array covariance matrices. Simulation results are provided to demonstrate the effectiveness of the proposed method.
The multiple signal classification (MUSIC) algorithm is computationally expensive in the application to joint two-dimensional (2-D) direction-of-arrival (DOA) and time-of-arrival (TOA) estimation based on uniform circular array (UCA) using orthogonal frequency-division multiplexing (OFDM) signal. This letter proposed an efficient way to compute the 3-D spatial-temporal spectrum. We extended the manifold separation technique, by which we obtained the 3-D discrete Fourier transform (DFT) form of the spectrum. On this basis, we proposed two 2-D DOA and TOA estimators called FFT-MUSIC and Two-step FFT-MUSIC. The former computed the spectrum by large size fast Fourier transform (FFT) to reduce the grid error in searching DOAs and TOAs. The latter roughly located the DOAs and TOAs by relatively small size FFT, followed by the subspace-based technique for a fine-grained searching within a local grid. Simulation results showed that both estimators can reduce the computation cost by one to two orders of magnitude, as compared to their conventional counterparts, while maintaining a similar accuracy.
The lack of sufficient spectral resources in many alternative positioning, navigation, and timing (APNT) systems for aviation has led to the problem of mutual interferences. Building APNT system with the cognitive radio and frequency-hopping (FH) techniques can resolve above problem, however, the main challenge is to achieve a long and high-precision range with high-speed FH signals. In this paper, we propose a novel ranging method called time-frequency matrix ranging (TFMR), which is based on the FH signals. Using the TFMR method, we built a jam-resistant APNT system to meet the accuracy and coverage requirements of aviation. We employed a dual-tone signal for the TFMR to estimate the pseudoranges between the ground stations and the aircrafts. One major challenge we faced was that what was good for ranging accuracy was bad for coverage. For example, increasing the dual-tone interval can improve the ranging accuracy; however, this led to a decrease in the unambiguous measurement range (UMR). To overcome this challenge, we employed different dual-tone intervals in different hops of the frequencyhopping signal. Finally, we formed a time-frequency matrix, so that a high UMR could be guaranteed without any harmful consequences on the ranging accuracy in the middle to high levels of the signal-to-noise ratio. The Cramér-Rao lower bound of TFMR is derived as the benchmark of the method. Using extensive simulations, we investigated the ranging performance of the TFMR method. The simulation results showed that the proposed TFMR could satisfy the APNT requirements of the Federal Aviation Administration.
Global navigation satellite system has been widely used, but it is vulnerable to jamming. In military satellite communications, frequency hopping (FH) signal is usually used for anti-jamming communications. If the FH signal can be used in satellite navigation, the anti-jamming ability of satellite navigation can be improved. Although a recently proposed time-frequency matrix ranging method (TFMR) can use FH signals to realize pseudorange measurement, it cannot transmit navigation messages using the ranging signal which is crucial for satellite navigation. In this article, we propose dual-tone binary frequency shift keying-based TFMR (DBFSK-TFMR). DBFSK-TFMR designs an extended time-frequency matrix (ETFM) and its generation algorithm, which can use the frequency differences in different dual-tone signals in ETFM to modulate data and eliminate the negative impact of data modulation on pseudorange measurement. Using ETFM, DBFSK-TFMR not only realizes the navigation message transmission but also ensures the precision and unambiguous measurement range of pseudo-range measurement. DBFSK-TFMR can be used as an integrated solution for anti-jamming communication and navigation based on FH signals. Simulation results show that DBFSK-TFMR has almost the same ranging performance as TFMR.
11 August 2025 in IEEE Wireless Communications Letters
Deep learning has been recognized as an effective method for indoor positioning, particularly in dense non-line-of-sight(NLOS) environments. However, most existing neural networks designed for indoor positioning view the two constituent components of channel state information(CSI) as real-valued inputs, which may discard some useful information embedded in the original CSI. In this letter, we propose a complex-valued convolutional neural network for indoor positioning named CCPNet, which incorporates local and global feature extraction modules and fully exploits the correlation between real and imaginary parts through complex-valued convolution. The experimental results demonstrate that, compared to existing real-valued neural networks, CCPNet exhibits more than 20% improvement in positioning accuracy while maintaining a relatively small number of parameters.