Geothermal energy has been widely proposed as a potential renewable energy to replace traditional fossil fuel energy. Hot dry rock (HDR) reservoirs were the main geothermal energy resources and usually consist of low‐permeability hard granite without fluid. Developing HDR requires water cyclically flowing between injection and production wells to extract heat energy. Hydraulic fracturing, as a key reservoir stimulation technology, can create the path of fluid cyclically flowing. However, few studies have investigated hydraulic induced artificial fractures in HDR geothermal formations. This paper investigated HDR geothermal reservoir stimulation characteristics and fracture patterns under different injection flow rates. Numerical simulations were conducted to model the laboratory tests. Results showed they were in good agreement, and this indicated the possibility of numerical simulation to predict hydraulic fracturing behavior under different injection flow rates. With the increase of injection flow rate, the fracture initiation pressures and breakdown pressures increased, and the propagation times and postfracturing pressures decreased. The fracture geometries were observed and analyzed, mean injection power was proposed, and results showed that it could be used to roughly estimate the fracture total lengths. Moreover, the fracture permeabilities based on the pressure data were calculated. These results can provide some reasonable advice for implementing reservoir stimulations on application to field‐scale HDR operation.

As an attractive renewable energy source, deep geothermal energy is increasingly explored. Granite is a typical geothermal reservoir rock type with low permeability, and hydraulic fracturing is a promising reservoir stimulation method which could obviously enhance the reservoir permeability. Previous hydraulic fracturing studies were mostly conducted on artificial samples and small cylindrical granites. The fracturing pressures of artificial samples and small real rock sample were much lower than that of field operation, and it was difficult to observe morphological changes in small rocks. Hence, this paper presents a hydraulic fracturing experimental study on large-scale granite with a sample size of 300 × 300 × 300 mm under high temperatures. Besides, injection flow rate is an important parameter for on-site hydraulic fracturing; previous studies usually only focused on breakdown pressure, and there is a lack of comprehensive analysis about fracturing pressure curves and fracturing characteristics caused by different injection flow rates. This study aims to investigate the influence of injection flow rate on different pressure curve characteristic parameters which are initiation pressure, propagation time, breakdown pressure, postfracturing pressure, fracture geometry, and fracture permeability. The mean injection power was proposed to roughly estimate the fracture total lengths. These results could provide some guidance for field-scale reservoir stimulation and heat extraction efficiency improvement.