Zdeněk Patočka

Dr. Zdeněk Patočka

Mendel University in Brno
orcid

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 November 2020 in Remote Sensing
Verified
Journal Article
Open access
PDF file
AFAngel Fernandez-Carrillo
Angel Fernandez-Carrillo
ZPZdeněk Patočka
Zdeněk Patočka
LDLumír Dobrovolný
Lumír Dobrovolný
AFAntonio Franco-Nieto
Antonio Franco-Nieto
Beatriz Revilla-RomeroBeatriz Revilla-Romero
Beatriz Revilla-Romero
Over the last decades, climate change has triggered an increase in the frequency of spruce bark beetle (Ips typographus L.) in Central Europe. More than 50% of forests in the Czech Republic are seriously threatened by this pest, leading to high ecological and economic losses. The exponential increase of bark beetle infestation hinders the implementation of costly field campaigns to prevent and mitigate its effects. Remote sensing may help to overcome such limitations as it provides frequent and spatially continuous data on vegetation condition. Using Sentinel-2 images as main input, two models have been developed to test the ability of this data source to map bark beetle damage and severity. All models were based on a change detection approach, and required the generation of previous forest mask and dominant species maps. The first damage mapping model was developed for 2019 and 2020, and it was based on bi-temporal regressions in spruce areas to estimate forest vitality and bark beetle damage. A second model was developed for 2020 considering all forest area, but excluding clear-cuts and completely dead areas, in order to map only changes in stands dominated by alive trees. The three products were validated with in situ data. All the maps showed high accuracies (acc > 0.80). Accuracy was higher than 0.95 and F1-score was higher than 0.88 for areas with high severity, with omission errors under 0.09 in all cases. This confirmed the ability of all the models to detect bark beetle attack at the last phases. Areas with no damage or low severity showed more complex results. The no damage category yielded greater commission errors and relative bias (CEs = 0.30–0.42, relB = 0.42–0.51). The similar results obtained for 2020 leaving out clear-cuts and dead trees proved that the proposed methods could be used to help forest managers fight bark beetle pests. These biotic damage products based on Sentinel-2 can be set up for any location to derive regular forest vitality maps and inform of early damage.

22 August 2023 in Global Change Biology
Verified
Journal Article
Open access
GFGiovanni Forzieri
Giovanni Forzieri
LDLoïc P. Dutrieux
Loïc P. Dutrieux
AEAgata Elia
Agata Elia
BEBernd Eckhardt
Bernd Eckhardt
GCGiovanni Caudullo
Giovanni Caudullo
PBPieter S. A. Beck
Pieter S. A. Beck
Insect and disease outbreaks in forests are biotic disturbances that can profoundly alter ecosystem dynamics. In many parts of the world, these disturbance regimes are intensifying as the climate changes and shifts the distribution of species and biomes. As a result, key forest ecosystem services, such as carbon sequestration, regulation of water flows, wood production, protection of soils, and the conservation of biodiversity, could be increasingly compromised. Despite the relevance of these detrimental effects, there are currently no spatially detailed databases that record insect and disease disturbances on forests at the pan‐European scale. Here, we present the new Database of European Forest Insect and Disease Disturbances (DEFID2). It comprises over 650,000 harmonized georeferenced records, mapped as polygons or points, of insects and disease disturbances that occurred between 1963 and 2021 in European forests. The records currently span eight different countries and were acquired through diverse methods (e.g., ground surveys, remote sensing techniques). The records in DEFID2 are described by a set of qualitative attributes, including severity and patterns of damage symptoms, agents, host tree species, climate‐driven trigger factors, silvicultural practices, and eventual sanitary interventions. They are further complemented with a satellite‐based quantitative characterization of the affected forest areas based on Landsat Normalized Burn Ratio time series, and damage metrics derived from them using the LandTrendr spectral–temporal segmentation algorithm (including onset, duration, magnitude, and rate of the disturbance), and possible interactions with windthrow and wildfire events. The DEFID2 database is a novel resource for many large‐scale applications dealing with biotic disturbances. It offers a unique contribution to design networks of experiments, improve our understanding of ecological processes underlying biotic forest disturbances, monitor their dynamics, and enhance their representation in land‐climate models. Further data sharing is encouraged to extend and improve the DEFID2 database continuously. The database is freely available at https://jeodpp.jrc.ec.europa.eu/ftp/jrc‐opendata/FOREST/DISTURBANCES/DEFID2/.

28 June 2019 in Sustainability
Verified
Journal Article
Open access
PDF file
Petr MaděraPetr Maděra
Petr Maděra
DVDaniel Volařík
Daniel Volařík
ZPZdeněk Patočka
Zdeněk Patočka
HKHana Kalivodová
Hana Kalivodová
JDJosef Divín
Josef Divín
PVPetr Vahalík
Petr Vahalík
Unsustainable overgrazing is one of the most important threats to the endemic and endangered population of dragon’s blood tree (Dracaena cinnabari) on Socotra Island (Republic of Yemen). However, there is a lack of information about the exact population size and its conservation status. We estimated the population size of D. cinnabari using remote sensing data. The age structure was inferred using a relationship between crown projection area and the number of branch sections. The conservation importance of each sub-population was assessed using a specially developed index. Finally, the future population development (extinction time) was predicted using population matrices. The total population size estimated consists of 80,134 individuals with sub-populations varying from 14 to 32,196 individuals, with an extinction time ranging from 31 to 564 years. Community forestry controlled by a local certification system is suggested as a sustainable land management approach providing traditional and new benefits and enabling the reforestation of endemic tree species on Socotra Island.

21 March 2018 in Remote Sensing
Verified
Journal Article
Open access
PDF file
PHPetr Hruza
Petr Hruza
Tomáš MikitaTomáš Mikita
Tomáš Mikita
NTNataliya Tyagur
Nataliya Tyagur
ZKZdenek Krejza
Zdenek Krejza
MCMiloš Cibulka
Miloš Cibulka
ZPZdeněk Patočka
Zdeněk Patočka
Currently, a large part of forest roads with a bituminous surface course constructed in the Czech Republic in the second half of the last century has been worn out. The aim of the study is to verify the possibility and the accuracy of the road wearing course damage detected by four different remote sensing methods: close range photogrammetry, terrestrial laser scanning, mobile laser scanning and airborne laser scanning. At the beginning of verification, cross sections of the road surface were surveyed geodetically and then compared with the cross sections created in the DTMs which were acquired using the four methods mentioned above. The differences calculated between particular models and geodetic measurements show that close range photogrammetry achieved an RMSE of 0.0110 m and the RMSE of terrestrial laser scanning was 0.0243 m. Based on these results, we can conclude that these two methods are sufficient for the monitoring of the asphalt wearing course of forest roads. These methods allow precise and objective localization, size and quantification of the road damage. By contrast, mobile laser scanning with an RMSE of 0.3167 m does not reach the required precision for the damage detection of forest roads due to the vegetation that affects the precision of the measurements. Similar results are achieved by airborne laser scanning, with an RMSE of 0.1392 m. As regards the time needed, close range photogrammetry appears to be the most appropriate method for damage detection of forest roads.

26 October 2022 in Forests
Verified
Journal Article
Open access
PDF file
Tomáš MikitaTomáš Mikita
Tomáš Mikita
DKDominika Krausková
Dominika Krausková
PHPetr Hruza
Petr Hruza
MCMiloš Cibulka
Miloš Cibulka
ZPZdeněk Patočka
Zdeněk Patočka
Forests make up 34.1% of the Czech Republic total area and forest roads account for nearly the same length (47,465 km) as all other roads administered by the state and its regions (55,738 km). Forest roads are not as intensively used as other roads. On the other hand, as logging trucks carry the maximum permitted load on roads and forests create a specific microclimate, forest roads are subject to rapid wear. A road wearing course is generally designed for 20 years of service and for a maximum damage level of 25% before they are supposed to be reconstructed. To ensure this life cycle is adhered to, more efficient, faster, and more flexible surface damage detection adaptable for forest environment is needed. As smartphones and their optical devices, i.e., new iPhones with LiDAR sensors, become more advanced, the option arises to perform laser scanning on road surfaces using smartphones applications. This work aimed to test this technology and its precision applicability to assessing damage to a forest wearing course and compare it with another hand-held personal laser scanner (PLShh), represented in this study by GeoSLAM ZEB Horizon scanner, and more precise terrestrial laser scanning (TLS) technology, represented in this study by Faro Focus 3D laser scanner, which have started to replace tacheometric wearing course damage surveying thanks to their greater precision. So, this study involved a comparison of three alternative laser scanning methods focused especially on these, which are implemented in new iPhones for tacheometric surveying. First, a Faro Focus 3D laser scanner was used for the TLS method. Second, the PLShh method was tested on a GeoSLAM ZEB Horizon scanner. Third, another PLShh method using an iPhone 13 Pro with applications 3D Scanner and Polycam was evaluated. If we are comparing positional height accuracy of PLShh to tacheometric surveying on reference cross position height coordinates, ZEB Horizon achieved devXY and devZ RMSE 0.108 m; 0.025 m; iPhone 13 Pro with 3D Scanner app devXY and devZ RMSE 0.185 m; 0.021 m, and with Polycam app devXY and devZ RMSE 0.31 m; 0.045. TLS achieved the best results with devXY RMSE 0.049 and devZ RMSE 0.0077. The results confirm that only the TLS scanner achieves precision values in height differences applicable for an assessment of forest road wearing course damage measurement comparable with tacheometric surveying. Surprisingly, comparing the PLShh scanners to the TLS technology, they achieved interesting results, comparing their transverse profiles and 3D objects as digital surface models (DSM) of the road to TLS in height position. In transverse profiles, ZEB Horizon achieved devZ RMSE 0.032 m; iPhone 13 Pro with 3D Scanner app devZ RMSE 0.017 m, and with Polycam app devZ RMSE 0.041 m compared to the TLS method measured using a Faro Focus 3D static laser scanner. Comparing forest road DSM to Faro Focus 3D, ZEB Horizon achieved devZ RMSE 0.028 m; iPhone 13 Pro with 3D Scanner app devZ RMSE 0.018 m and with Polycam devZ RMSE 0.041 m. These results in height differences show that the height accuracy of PLShh achieves precision, which is applicable to determining the current shape of forest road wearing course compared to the required roof shape gradient. However, further testing provided the insight that such a kind of PLShh measurement is still only possible to use for the identification of a transverse profile shape, as in length measurement the length error increases. All PLShh are able to capture the current shape of forest road cross profile, but still they cannot be used for any design or calculation of material measurement needed for wearing course repair.

17 March 2020 in Sensors
Verified
Journal Article
Open access
PDF file
Tomáš MikitaTomáš Mikita
Tomáš Mikita
Marie BalkováMarie Balková
Marie Balková
ABAleš Bajer
Aleš Bajer
MCMiloš Cibulka
Miloš Cibulka
ZPZdeněk Patočka
Zdeněk Patočka
This paper reviews the use of modern 3D image-based and Light Detection and Ranging (LiDAR) methods of surface reconstruction techniques for high fidelity surveys of small rock outcrops to highlight their potential within structural geology and landscape protection. LiDAR and Structure from Motion (SfM) software provide useful opportunities for rock outcrops mapping and 3D model creation. The accuracy of these surface reconstructions is crucial for quantitative structural analysis. However, these technologies require either a costly data acquisition device (Terrestrial LiDAR) or specialized image processing software (SfM). Recent developments in augmented reality and smartphone technologies, such as increased processing capacity and higher resolution of cameras, may offer a simple and inexpensive alternative for 3D surface reconstruction. Therefore, the aim of the paper is to show the possibilities of using smartphone applications for model creation and to determine their accuracy for rock outcrop mapping.