Nylon filament is a widely used thermoplastic material in extrusion-based 3D printing, favored for its strength, durability, and excellent printability. It enables the fabrication of parts with complex geometries, high design flexibility, and cost-effective production, making it ideal for both prototyping and functional components. However, one significant drawback of nylon is its hygroscopic nature—it readily absorbs moisture from the surrounding environment, often at a rapid rate. This moisture uptake can negatively impact the filament’s performance during printing, leading to poor surface finish, reduced mechanical strength, and altered thermal behavior in the final printed parts. To better understand the effects of moisture absorption, this study investigates the mechanical and thermal properties of nylon parts printed using filaments with varying levels of moisture content. The nylon filament was conditioned in a controlled humidity chamber for different durations to simulate moisture exposure over time. Specimens were then printed using these conditioned filaments, and a series of tests were performed to assess their mechanical integrity and thermal stability. By analyzing the test results, the study aims to establish a correlation between filament moisture content and part quality, offering valuable insights into the degradation mechanisms and guiding best practices for filament handling and storage in nylon 3D printing applications.
Polyether-ether-ketone (PEEK) is a recently commonly used high-performance thermoplastic material with high heat resistance, high chemical resistance, high water resistance, and high wear resistance. Polyether-ether-ketone products with complex structures manufactured through the 3D printing process of fused filament fabrication (FFF) are emerging in the medical field. However, similar to other plastics, PEEK materials are also hygroscopic. This may have an impact on 3D printed products. The effect of storage time of filament on 3D printed PEEK products under specific temperature and humidity conditions has not been further explored. This study is mainly to explore the moisture absorption of PEEK filament for different storage time and the effect of moisture absorption on the performance of 3D printed PEEK products. The correlation between storage time and moisture absorption is verified by experiment. It is found that moisture will affect the surface quality of PEEK products. In addition, the mechanical test results show that the increase in the amount of water absorbed leads to the decrease of material properties, such as tensile strength, density, and hardness. Therefore, it is recommended to store unused or leftover PEEK filaments under vacuum drying conditions. For PEEK filaments that are being printed, it should be ensured to replace them every less than 24 h.