InSAR technology provides a powerful tool for detecting large-scale surface deformation. In particular, the newly developed DS-InSAR method fused PS points has obvious advantages in monitoring bare land and vegetation covered areas, but at present, there is a lack of effectiveness evaluation of this method. Therefore, this paper takes Hongta District of Yuxi City as an example. The 29 scenes sentinel-1A data from January 2019 to December 2019 were processed and analyzed using the DS-InSAR method fused PS points. The research results show that the position and deformation trend of the inversion results of the three methods are highly consistent, the correlation between DS-InSAR method fused PS points and PS- InSAR and SBAS-InSAR methods is 0.9473 and 0.8583, respectively. But the spatial density of the measurement points (MPs) obtained by the DS-InSAR method of PS points is 11 times and 4 times that of the PS-InSAR method and SBAS-InSAR method respectively. It clearly shows that DS-InSAR method fused PS points has greater advantages than PS-InSAR and SBAS-InSAR methods in deformation mapping displacement, because the MPs density is higher. It is conducive to the detailed analysis of the spatio-temporal characteristics and deformation mechanism of deformation.
During routine bridge maintenance, edge detection allows the partial condition of the bridge to be viewed. However, many edge detection methods often have unsatisfactory performances when dealing with images with complex backgrounds. Moreover, the processing often involves the manual selection of thresholds, which can result in repeated testing and comparisons. To address these problems in this paper, the wavelet transform modulus maxima method is used to detect the target image, and then the threshold value of the image can be determined automatically according to the OTSU method to remove the pseudo-edges. Thus, the real image edges can be detected. The results show that the information entropy and SSIM of the detection results are the highest when compared with the commonly used Canny and Laplace algorithms, which means that the detection quality is optimal. To more fully illustrate the advantages of the algorithms, images with more complex backgrounds were detected and the processing results of the algorithms in this paper are still optimal. In addition, the automatic selection of thresholds saves the operator’s effort and improves the detection efficiency. Thanks to the combined use of the above two methods, detection quality and efficiency are significantly improved, which has a good application in engineering practice.
21 September 2019 in Journal of Materials Research