In this study, a time-domain numerical method based on three-dimensional potential flow was developed to analyze the hydrodynamic characteristics of an inclined oscillating-water-column (OWC) wave energy converter (WEC). A finite element method was applied to solve the potential flow around and inside the OWC chamber. A turbine–chamber interaction was considered to take into account the pressure drop inside the OWC chamber, which is a nonlinear function of airflow speed via turbine operation. The instantaneous pressure drop was updated on the free-surface boundary condition inside the chamber in the time-domain to account for the coupling effect between the turbine and the chamber. The present numerical method was verified by comparing it with the model test results. The hydrodynamic characteristics of an inclined OWC chamber in terms of potential flow, such as the water column motion and the three-dimensional flow distribution around the chamber, were investigated. In terms of hydrodynamic performance, the energy conversion efficiency of the chamber showed a nonlinear response characteristic dependent on the incident wave height. In addition, numerical calculations were carried out to clarify the relationship between the main geometric parameters and the hydrodynamic response of the inclined OWC chamber.

In general, permanent magnet (PM) motors are driven by a pulse width modulation (PWM) voltage source inverter for vector control. The generated PWM signals cause high-frequency voltage components at the carrier frequency. Such components can increase the electromagnetic losses, thereby necessitating the consideration of the phase current corresponding to the carrier harmonics. This study aims to examine the feasibility of high-speed permanent magnet (PM) motors in which rare-earth magnets are replaced by ferrite magnets, by considering the current harmonics. The electromagnetic characteristics of a high-speed motor with rare-earth and ferrite PMs were analyzed considering the current harmonics. Based on the existing rare-earth magnet model, a ferrite magnet model with the same performance was developed to perform a comparative analysis. The findings were validated via comparison with the experimental results of the manufactured models.

Wave power marine concrete structures generate electrical energy using waves. They are exposed to a multi-deterioration environment because of air and hydrostatic pressure and chloride attack. In this study, the effect of air pressure repeatedly generated by water level change of wave power marine concrete structures on the chloride-ion diffusion of marine concrete was analyzed. The chloride-ion diffusion of wave power marine concrete structures was evaluated. The results show that the air chamber and bypass room, which were subjected to repetitive air pressures caused by water level changes, showed a higher water-soluble chloride-ion content compared to the generator room and docking facility, which were subjected to atmospheric pressure. Field exposure tests and indoor chloride attack tests were performed using fabricated specimens to analyze the effect of pressure on chloride-ion penetration. It was confirmed that Portland blast furnace slag had a greater inhibitory effect on chloride-ion penetration than ordinary Portland cement. The concrete specimens subjected to pressure showed increased capillary pores and micro-cracks. We devised an equation for calculating the diffusion coefficient based on measured data and estimating the diffusion coefficient for the location receiving repeated air pressure by using the diffusion coefficient of the location receiving general atmospheric pressure.

This study analyzes and verifies the electromagnetic performance and thrust characteristics of linear magnetic gears using subdomain-based analytical methods. By simplifying the analytical model, the governing equations of each domain are calculated based on the Maxwell equation. In addition, the undetermined coefficients of the governing equations are derived using four boundary conditions. In magnetic gears, where power transmission is important, force characteristics are also important. The force characteristics were calculated using the undetermined coefficients and the Maxwell stress tensor.

This study conducted a numerical investigation on the non-linear motion problems between a Salter duck-type rotor and large waves using CFD simulations. Regular waves of five different wave heights were generated. First, the linear motion of the rotor from the CFD simulation was verified by comparing it with the existing experimental and frequency domain analysis results. Then, a series of CFD simulations were performed to investigate the non-linear motions of the rotor. In the case of a lower wave height, the CFD simulation results were in good agreement with the experimental and frequency domain analysis results. However, as the wave height increased, the resonance periods were different in each other. In addition, the magnitudes of normalized pitch motions by the wave heights decreased as the wave heights increased. To investigate the aforementioned phenomena, the pitch motion equation was examined using separate CFD simulations. The results showed that changing the restoring moments induced changes in the maximum pitch motions and magnitudes of the normalized pitch motions. In the case of a higher wave height, non-linear phenomena and the changing restoring moments induced non-linear motion.

A numerical study was performed to investigate the applicability of the linear decomposition method for the hydrodynamic energy conversion of an oscillating-water-column type wave energy converter (OWC-WEC). Hydrodynamic problems of the OWC chamber were decomposed into the excitation and radiation problems with the time-domain numerical method based on the linear potential theory. A finite element method was applied to solve the potential flow in the entire fluid domain including OWC chamber structure. The validity of the linear decomposition method was examined by comparing with the direct interaction method for the turbine–chamber interaction based on the linear pressure drop characteristics. In order to estimate the hydrodynamic energy conversion performance under the irregular waves, the response spectrum method was applied with the transfer function based on the linear decomposition method. Under the various irregular wave conditions, the pneumatic power of OWC-WEC calculated by the response spectrum based on the linear decomposition method agreed well with the direct irregular wave simulation results.