This critical review provides an overview of sensitivity-enhancement strategies and a systematic, quantitative analysis of field-effect transistor (IS-FET/BioFET) sensor literature.
Smart radiative cooling devices based on thermochromic materials such as vanadium dioxide (VO 2 ) are of practical interest for temperature regulation and artificial homeostasis, i.e., maintaining stable equilibrium conditions for survival, both in terrestrial and space applications. In traditional solar reflector configurations, solar absorption in the VO 2 layer is a performance limiting factor due to the multiple reflections of sunlight in the stack. Here, we demonstrate a visually transparent, smart radiator panel with reduced solar absorption. An Al‐doped ZnO transparent conducting oxide layer acts as a frequency selective infrared back‐reflector with high transmission of solar radiation. In this study we make use of high‐quality VO 2 thin films deposited using atomic layer deposition and optimized annealing process. Patterning of the VO 2 layer into a metasurface results in a further reduction of the solar absorption parameter α to around 0.3, while exhibiting a thermal emissivity contrast Δ ε of 0.26 by exploiting plasmonic enhancement effects. The VO 2 metasurface provides a visual spectrum transmission of up to 62%, which is of interest for a range of applications requiring visual transparency. The transparent smart metasurface thermal emitter offers a new approach for thermal management in both space and terrestrial radiative cooling scenarios.
The unique structural transition of VO2 between dielectric and metallic phases has significant potential in optical and electrical applications ranging from volatile switches and neuromorphic computing to smart devices for thermochromic control and radiative cooling. Critical condition for their widespread implementation is scalable deposition method and reduction of the phase transition to near room temperature. Here, a W:VO2 process based on atomic layer deposition (ALD) is presented that enables precise control of W‐doping at the few percent level, resulting in a viable controllable process with sufficient W incorporation into VO2 to reduce the phase transition to room temperature. It is demonstrated that the incorporation of 1.63 at.% W through ALD growth leads to a state‐of‐the‐art phase transition at 32 °C with emissivity contrast between the low‐temperature and high‐temperature phase exceeding 40% in a metasurface‐based radiative cooling device configuration. The process is shown to be viable on 200 mm silicon substrates as well as flexible polyimide films. The full and self‐consistent temperature‐dependent characterization of the W‐doped VO2 using spectroscopic ellipsometry, electrical conductivity, mid‐wave infrared camera, and Fourier transform infrared emissivity, allows for a fully validated material model for the theoretical design of various smart and switchable device applications.
The “one‐to‐many” problem is a typical challenge that faced by many machine learning aided inverse nanophotonics designs where one target optical response can be achieved by many solutions (designs). Although novel training approaches, such as tandem network, and network architecture, such as the mixture density model, have been proposed, the critical problem of solution degeneracy still exists where some possible solutions or solution spaces are discarded or unreachable during the network training process. Here, we report a solution to the “one‐to‐many” problem by employing a conditional generative adversarial network (cGAN) that enables generating sets of multiple solution groups to a design problem. Using the inverse design of a transmissive Fabry–Pérot‐cavity‐based color filter as an example, our model demonstrates the capability of generating an average number of 3.58 solution groups for each color. These multiple solutions allow the selection of the best design for each color which results in a record high accuracy with an average index color difference Δ E of 0.44. The capability of identifying multiple solution groups can benefit the design manufacturing to allow more viable designs for fabrication. The capability of our cGAN is verified experimentally by inversely designing the RGB color filters. We envisage this cGAN‐based design methodology can be applied to other nanophotonic structures or physical science domains where the identification of multi‐solution across a vast parameter space is required.