In this paper, a 24 GHz direct conversion receiver (DCR) for frequency-modulated continuous-wave (FMCW) ranging radar based on low flicker noise mixer in 90 nm silicon-on-insulator (SOI) CMOS technology is presented. A low-noise and low-power low-noise-amplifier (LNA) adopting simultaneous noise and input matching (SNIM) method is designed. Neutralized technology and boost inductor are introduced to improve performance. The measurement results of standalone LNA show that the peak gain is 17.2 dB at 23.8 GHz and the −3 dB bandwidth is around 2.2 GHz from 22.8 GHz to 25 GHz. The LNA achieves an average 3 dB NF within the 24 GHz band. A current-bleeding mixer is used to lower noise and the factors influencing flicker noise have been discussed. Proper element values and local oscillator (LO) power have been chosen to make the mixer low-noise. Measurement results illustrate that the receiver exhibits 20.3 dB peak gain, 7 dB SSB noise figure (NF) and −22 dBm IP1dB. Flicker noise of the mixer and the receiver are measured respectively and the noise knee-point of receiver is observed 60 kHz. The receiver consumes only 16 mW with chip area of 0.65 mm2 including pads. The results demonstrate that the proposed receiver can be a promising candidate for FMCW ranging radar.
This paper presents a low power two-stage single-end (SE) 28 GHz low-noise amplifier (LNA) in 90 nm silicon-on-insulator (SOI) CMOS technology for 5G applications. In this design, the influence of bias circuit is discussed. The 1200 Ω resistor which was adopted in bias circuit can feed DC voltage as well as keep whole circuit unconditionally stable. The gate bias points are set to 0.55 V to make the circuit low-power and temperature-stable. Measurement results illustrated that the LNA achieved a maximum small signal gain of 18.1 dB and an average 3.1 dB noise figure (NF) in operating frequency band. Measured S11 was below −10 dB between 25 GHz and 29 GHz and reverse isolation S12 was below −25 dB throughout the band. It consumed only 4 mW by proper selection of bias point with core area of 0.16 mm2 without pads. The fabricated LNA has demonstrated a gain variation of 3 dB and a NF variation of 1.9 dB from −40 °C to 125 °C with power variation of 0.8 mW. It suggests that the proposed SOI CMOS LNA can be a promising candidate for 5G applications.
In this paper, the influence of the DC-blocking capacitors leveraged in coplanar waveguide (CPW) matching networks is studied. CPW matching networks with series-connected DC-blocking capacitors are less sensitive to capacitance and are adopted in a 28 GHz power amplifier (PA). The PA targeting fifth-generation (5G) phased array is developed in 90 nm silicon-on-insulator complementary-metal-oxide-semiconductor (SOI CMOS) technology. A stacked field-effect-transistor (FET) architecture is elected in the output stage to boost the output power and reduce the die area. The PA with a core area of 0.31 mm2 demonstrates a maximum small signal gain of 13.7 dB and a −3 dB bandwidth of 6.3 GHz (22.9–29.2 GHz). The PA achieves a measured saturated output power (Psat) of 14.4 dBm and a peak power added efficiency (PAE) of 25% for continuous wave signals. At 24/25.6/28 GHz, the PA achieves +7.87/+9.16/+10.7 dBm measured output power and 6.21%/8.11%/10.17% PAE at −25 dBc error vector magnitude(EVM) for a 250 MHz-wide 64-quadrature amplitude modulation (64-QAM). The developed linear PA provides a great potential for low-cost 5G phased array transceivers.