1. Institute of Biomedical Systems and Biotechnology, Peter the Great St. Petersburg Polytechnic University, Polytechnicheskaya Street 29, 195251 Saint Petersburg, Russia
+1
Dr. Elena Dresvyanina
1. Institute of Biomedical Systems and Biotechnology, Peter the Great St. Petersburg Polytechnic University, Polytechnicheskaya Street 29, 195251 Saint Petersburg, Russia
This paper discusses the mechanical and physicochemical properties of film matrices based on chitosan, as well as the possibility of optimizing these properties by adding chitin nanofibrils. It is shown that with the introduction of chitin nanofibrils as a filler, the mechanical stability of the composite materials increases. By varying the concentration of chitin nanofibrils, it is possible to obtain a spectrum of samples with different bioactive properties for the growth of human dermal fibroblasts. Film matrices based on the nanocomposite of chitosan and 5 wt % chitin nanofibrils have an optimal balance of mechanical and physicochemical properties and bioactivity in relation to the culture of human dermal fibroblasts.
Biocompatible electrically conducting chitosan-based films filled with single-wall carbon nanotubes were obtained. Atomic force microscopic studies of the free surface topography revealed a change in the morphology of chitosan films filled with single-wall carbon nanotubes. Introducing 0.5 wt.% of single-wall carbon nanotubes into chitosan results in an increase in tensile strength of the films (up to ~180 MPa); the tensile strain values also rise up to ~60%. It was demonstrated that chitosan films containing 0.1–3.0 wt.% of single-wall carbon nanotubes have higher conductivity (10 S/m) than pure chitosan films (10−11 S/m). The investigation of electrical stimulation of human dermal fibroblasts on chitosan/single-wall carbon nanotubes film scaffolds showed that the biological effect of cell electrical stimulation depends on the content of single-walled carbon nanotubes in the chitosan matrix.
The temperature dependences of elastic and relaxation properties of films of salt and base forms of chitosan were obtained by methods of dynamic mechanical analysis. It was estimated that the...
Bioactive biodegradable chitosan films containing chitin nanofibrils have been developed for use as face masks in cosmetology. It was found that thermal modification of chitosan films promotes the transformation of the polymer into insoluble form without the use of alkali or aldehydes. The structure and properties of the films were studied by IT spectroscopy, atomic force microscopy, thermogravimetric analysis, and X-ray structural analysis. Analysis of infrared (IR) spectra showed that the addition of nanofibrils accelerates the process of thermal transformation in the composite films. This is apparent from the observed increase in the intensity ratio of 1030 cm−1\1580 cm−1 peaks in the spectrum of the thermally treated film (as compared to the spectrum of the initial sample and the spectrum of a chitosan film without chitin nanofibrils). The prepared composite films containing chitin nanofibrils possess improved mechanical characteristics: tensile strength 99 MPa and tensile strain 14%. The tetrazolium bromide (MTT) test revealed good viability of human dermal fibroblasts cultivated in the presence of the conditioned medium obtained after incubation of all types of films in the nutrient medium. The used process of thermal modification of chitosan and composite films (which is efficient and environmentally safe) allows one to prepare bioactive materials for applications in medicine and cosmetology.