: The main purpose of this work is to study the effectiveness of using FeCeOx nanocomposites doped with Nb2O5 for the purification of aqueous solutions from manganese. X-ray diffraction, energy–dispersive analysis, scanning electron microscopy, vibrational magnetic spectroscopy, and mössbauer spectroscopy were used as research methods. It is shown that an increase in the dopant concentration leads to the transformation of the shape of nanoparticles from spherical to cubic and rhombic, followed by an increase in the size of the nanoparticles. The spherical shape of the nanoparticles is characteristic of a structure consisting of a mixture of two phases of hematite (Fe2O3) and cerium oxide CeO2. The cubic shape of nanoparticles is typical for spinel-type FeNbO4 structures, the phase contribution of which increases with increasing dopant concentration. It is shown that doping leads not only to a decrease in the concentration of manganese in model solutions, but also to an increase in the efficiency of adsorption from 11% to 75%.
25 March 2024 in ACS Applied Materials & Interfaces
Based on the methods of non-equilibrium thermodynamics, it was found that the implementation of spontaneous processes with positive entropy production during friction leads to an increase in the wear intensity. Non-spontaneous processes with negative entropy production lead to a decrease in wear intensity. The tribological characteristics of diamond-like carbon (DLC) with different silicon content were studied. The wear intensity practically does not correlate with the friction coefficient. It is shown that DLC with the highest content of diamond-like inclusions (sp3) in the coating has the highest wear rate. In the same DLC, the most intense sp3–sp2 transformation during friction was observed. The sp3–sp2 transformation is a spontaneous process.
1 April 2024 in ACS Applied Materials & Interfaces
Laser attracts more attention and it could cause material failure by its high energy. Carbon fiber resin composites are widely used in aerospace vehicles experiencing dramatic damage to their surface if exposed to high-energy laser irradiation. The available studies on irradiation behavior are mainly focused on pulsed lasers and bulk composites, and investigations of thin laminar structures under continuous-wave laser irradiation have rarely been reported. In this study, the damage behavior of laminar carbon fiber epoxy resin composites (CFE composites) was studied. Using a threshold model of resin pyrolysis, CFE composite is observed to be damaged at 0.18 s when irradiated at 100 W/cm2, and if the laser power density is increased to 200 W/cm2 for 2 s, no resin remains on the fiber surface, which is now completely exposed. With an increase in power density and irradiation time, the ablation rate always shows an upward trend: the ablation region expands and the separation of layers in the interior appears, which can reach 0.01156 g/s when irradiated at 100 W/cm2 for 5 s. The damage mechanism of CFE composite was also revealed by the temperature evolution data, thermogravimetric analysis, and composition change.
3 October 2024 in Solar Energy Materials and Solar Cells