The influence of physiological factors on the solubility of drug compounds has been thoroughly investigated in humans. However, as these factors vary between species and since many in vivo studies are carried out in rats or mice, it has been difficult to establish sufficient in vitro in vivo relations. The aim of this study was to develop a physiologically relevant in vitro dissolution model simulating the gastrointestinal (GI) fluids of fasted rats and compare it to previously published in vitro and in vivo data. To develop the in vitro model, the pH was measured in situ in six segments of the GI tract of anesthetised rats, then the fluids from the stomach, the proximal and the distal small intestine were collected and characterized with regard to osmolality, and bile acid and phospholipid concentration. The pH and osmolality were found to increase throughout the GI tract. The bile acids and phospholipids were present in high concentrations in the proximal small intestine, and the bile acid concentration doubled in the distal part, where the phospholipid concentration decreased. Matrix-assisted laser desorption ionisation mass spectrometry imaging was applied on a cross section of the small intestine, to study which bile acids and phospholipid classes were present in the small intestine of rats. Both cholic acid, taurocholic acid and glycocholic acid were detected, and phosphatidylcholine (34:2) was found to be mainly present in the intestinal wall or mucus, whereas lysophosphatidylcholine (16:0) was also detected in the lumen. Based on these observations, biorelevant media were developed to simulate fluids in the stomach and the proximal part of the small intestine in fasted rats. The media were implemented in a two-step in vitro dissolution model, which was found to better predict the in vivo performance of furosemide, when compared to previously published in vitro and in vivo data.

An increased interest in colonic drug delivery has led to a higher focus on the design of delivery devices targeting this part of the gastrointestinal tract. Microcontainers have previously facilitated an increase in oral bioavailability of drugs. The surface texture and shape of microcontainers have proven to influence the mucoadhesion ex vivo. In the present work, these findings were further investigated using an in situ closed-loop perfusion technique in the rat colon, which allowed for simultaneous evaluation of mucoadhesion of the microcontainers as well as drug absorption. Cylindrical, triangular and cubic microcontainers, with the same exterior surface area, were evaluated based on in vitro release, in situ mucoadhesion and in situ absorption of amoxicillin. Additionally, the mucoadhesion of empty cylindrical microcontainers with and without pillars on the top surface was investigated. From the microscopy analysis of the colon sections after the in situ study, it was evident that a significantly higher percentage of cubic microcontainers than cylindrical microcontainers adhered to the intestinal mucus. Furthermore, the absorption rate constants and blood samples indicated that amoxicillin in cubic microcontainers was absorbed more readily than when cylindrical or triangular microcontainers were dosed. This could be due to a higher degree of mucoadhesion for these particular microcontainers.

During the past decades, microdevices have been evaluated as a means to overcome challenges within oral drug delivery, thus improving bioavailability. Fabrication of microdevices is often limited to planar or simple 3D designs. Therefore, this work explores how microscale stereolithography 3D printing can be used to fabricate radiopaque microcontainers with enhanced mucoadhesive geometries, which can enhance bioavailability by increasing gastrointestinal retention. Ex vivo force measurements suggest increased mucoadhesion of microcontainers with adhering features, such as pillars and arrows, compared to a neutral design. In vivo studies, utilizing planar X‐ray imaging, show the time‐dependent gastrointestinal location of microcontainers, whereas computed tomography scanning and cryogenic scanning electron microscopy reveal information about their spatial dynamics and mucosal interactions, respectively. For the first time, the effect of 3D microdevice modifications on gastrointestinal retention is traced in vivo, and the applied methods provide a much‐needed approach for investigating the impact of device design on gastrointestinal retention.

Oral drug delivery remains the most preferred administration route, and new oral delivery concepts continuously arise to enable oral delivery of new therapeutics. This study investigates how colloidal structures in five simulated intestinal fluids (SIFs) with varying bile salt and phospholipid compositions influence drug solubility, nanoparticle aggregation and cytotoxicity, and mucoadhesion of nanoparticles and polymers. For the poorly water‐soluble drugs indomethacin and felodipine, colloidal structure size in SIFs varies with solubility, and felodipine's solubility is influenced by the lipid composition. Nanoparticles, including polymersomes and mesoporous silica nanoparticles with different surface charges, are characterized in each medium. Dynamic light scattering reveals three interaction modalities: interaction, aggregation, and combination, depending on nanoparticle type and fluid composition. Additionally, interaction patterns correlate with Caco‐2 cell cytotoxicity. Quartz crystal microbalance with dissipation analysis reveals that both particle and polymer interactions with mucin are significantly altered in SIFs. For nanoparticles, mucin interactions differ depending on the type of nanoparticle. For the polymers, polyethylene oxide completely loses mucin interaction in SIFs, while chitosan retains partial mucoadhesion. These findings emphasize the importance of not only studying drug properties, but also cell compatibility and mucoadhesion of polymers and nanoparticles, in physiologically relevant conditions.