With the introduction of various antennas in the field of antenna technology, most of the constraints related to the transmission and receiving of the signals at different intervals have been resolved. By the rapid growth in industry and consequently high demands in the communication arena, the conventional antennas are unable to respond to these extended requirements. However, those initial antennas were suitably used in the field of technology. In the recent decades, by introducing new antenna technologies such as metamaterial structures, substrate integrated waveguide (SIW) structures and microstrip antennas with various feeding networks could meet the demands of the current systems. As stated before, in the frequency ranges of below 30 GHz, antenna size and bandwidth are of the important issues, so that novel antennas can be created in low frequencies, which are able to achieve reliable radiation properties when combined with new multiband antennas. Generally, transmission lines are practical in low frequencies and short distances, while higher frequencies are mainly used due to bandwidth goals. This chapter is organized into three subsections related to the 5G wireless communication systems: antennas below 15 GHz or accordingly antennas with wavelength less than 1/20; antennas operating between 15 and 30 GHz; higher frequency antennas or millimeter-wave antennas, which are desired for above 40 GHz.

This letter presents a multifunctionality reconfigurable substrate-integrated waveguide (SIW) filter embedded in a microstrip line. The proposed filter used an electromagnetic bandgap structure (EBG) to compact the size and improve the electromagnetic features. The SIW filter consists of a three-cell EBG with metallic circular-shaped connected to the ground through cylindrical vias. Firstly, the base SIW structure offers a wide passband filtering response, and then, to obtain selective passband, wide band rejection, and controllable resonance frequencies, a three-cell EBG along with four diodes has been attached. The filter is designed and printed on a Rogers 4003 substrate with a thickness of 1mm and is experimentally validated for functionalities operated at three modes with an average 3dB bandwidth of 115MHz in each frequency. In addition to that, two transmission zeros (TZ) have been produced in the upper band frequency. The filters response is also tunable by turning the diode off or on and changing the main parameters of EBG, the gab, and the position between cells. The study explores resonance frequency alterations in a three-state system of on/off. By eliminating or diminishing specific modes, and incorporating diodes, distinct resonance behaviors are observed. Moreover, shifting frequency resonance in a multiparameter system has been investigated. Increasing B1 induces a significant shift to lower values, while an increase in D1 leads to a decrease in the first and second resonance frequencies and an upward shift in the third. The designed filter has been fabricated and tested to compare and confirm simulated responses. Simulation and measurement results are in good agreement. The S-parameters of measured results gained a good response (15dB) within the passbands and stopbands and an insertion loss of 1.5dB suitable for 5G and Wi-Fi systems.