Partial Discharges (PDs) are one of the most important classes of ageing processes that occur within electrical insulation. The measurement of PDs is useful in the diagnosis of electrical equipment because PDs activity is related to different ageing mechanisms. Classical Phase-Resolved Partial Discharge (PRPD) patterns are able to identify PD sources when they are related to a clear degradation process and when the noise level is low compared to the amplitudes of the PDs. However, real insulation systems usually exhibit several PD sources and the noise level is high, especially if measurements are performed on-line. High-frequency (HF) sensors and advanced signal processing techniques have been successfully applied to identify these phenomena in real insulation systems. In this paper, spectral power analyses of PD pulses and the spectral power ratios at different frequencies were calculated to classify PD sources and noise by means of a graphical representation in a plane. This technique is a flexible tool for noise identification and will be useful for pulse characterization.

Partial discharge (PD) detection is a widely extended technique for electrical insulation diagnosis. Ultrahigh-frequency detection techniques appear as a feasible alternative to traditional methods owing to their inherent advantages such as the capability to detect PDs online and to locate the piece of equipment with insulation problems in substations and cables. In this paper, four antennas are thoroughly studied by means of their theoretical and experimental behavior when measuring electromagnetic pulses radiated by PD activity. The theoretic study of the band of frequencies in which the pulse emits and the measurement of the parameters $S_{11}$ are complemented with the frequency response and wavelet transform of a set of 500 time signals acquired by the antennas, and the results are analyzed in detail.

In order to obtain partial discharge (PD) measurements a PD measuring probe based on a Rogowski coil was constructed. Up to now, Rogowski coils had been used to measure high level currents. In this article, the design of a Rogowski coil to measure very low currents, but with a very high frequency, such as partial dischages, is exposed. The Rogowski coil used as a PD transducer is very advantageous because it is inexpensive and easy to use. Besides, it provides the needed bandwidth for this application.