A silicon electron pump operating at the temperature of liquid helium has demonstrated repeatable operation with sub-ppm accuracy. The pump current, approximately 168 pA, is measured by three laboratories, and the measurements agree with the expected current ef within the uncertainties which range from 0.2 ppm to 1.3 ppm. All the measurements are carried out in zero applied magnetic field, and the pump drive signal is a sine wave. The combination of simple operating conditions with high accuracy demonstrates the possibility that an electron pump can operate as a current standard in a National Measurement Institute. We also discuss other practical aspects of using the electron pump as a current standard, such as testing its robustness to changes in the control parameters, and using a rapid tuning procedure to locate the optimal operation point.
We present a measurement and analysis scheme for determining traceable thermodynamic temperature at cryogenic temperatures using Coulomb blockade thermometry. The uncertainty of the electrical measurement is improved by utilizing two sampling digital voltmeters instead of the traditional lock-in technique. The remaining uncertainty is dominated by that of the numerical analysis of the measurement data. Two analysis methods are demonstrated: numerical fitting of the full conductance curve and measuring the height of the conductance dip. The complete uncertainty analysis shows that using either analysis method the relative combined standard uncertainty ( k = 1) in determining the thermodynamic temperature in the temperature range from 20 mK to 200 mK is below 0.5%. In this temperature range, both analysis methods produced temperature estimates that deviated from 0.39% to 0.67% from the reference temperatures provided by a superconducting reference point device calibrated against the Provisional Low Temperature Scale of 2000.
We report proof-of-concept experiments on an optically driven Josephson voltage standard based on a mode-locked laser (MLL), a time-division multiplexer, and a cryogenic ultrafast photodiode driving an overdamped Josephson junction array (JJA). Our optical pulse pattern generator (PPG) concept builds on the capability of MLLs to produce trains of picosecond-wide optical pulses with little amplitude and temporal spread. Our present setup enables multiplication of the original 2.3 GHz pulse repetition frequency by a factor of 8. A commercial photodiode converts the optical pulses into about 25 ps wide electrical pulses in liquid helium several cm from the JJA. Using a custom-made MLL, we can drive a JJA with a low critical current of 360 μA at multiple Shapiro steps. We have performed experiments with pulse pairs whose time interval can be set freely without distorting the shapes of individual pulses. Experimental results are in qualitative agreement with theoretical simulations, and they demonstrate, e.g., crossover in the Shapiro step pattern when the time interval between the pulses is approximately equal to the inverse of the characteristic frequency of the JJA. However, there are quantitative discrepancies, which motivate an improved integration of photodiodes and JJAs to improve both the understanding and fidelity of Josephson Arbitrary Waveform Synthesizers. Considering future quantum technologies in a wider perspective, our optical approach is a potential enabler for fast and energy-efficient pulse drive without an expensive high-bandwidth electrical PPG and without high-bandwidth electrical cables that yield too high thermal conductance between cryogenic and room temperatures.
20 October 2016 in International Journal of Thermophysics
We have fabricated disordered superconducting nanowires of molybdenium silicide. A molybdenium nanowire is first deposited on top of silicon, and the alloy is formed by rapid thermal annealing. The method allows tuning of the crystal growth to optimize e.g. the resistivity of the alloy for potential applications in quantum phase slip (QPS) devices and superconducting nanowire single-photon detectors. The wires have effective diameters from 42 to 79 nm, enabling the observation of crossover from conventional superconductivity to regimes affected by thermal and quantum fluctuations. In the smallest diameter wire and at temperatures well below the superconducting critical temperature, we observe residual resistance and negative magnetoresistance, which can be considered as fingerprints of QPSs.