End-to-end calibration of the Microwave Imaging Radiometer by Aperture Synthesis (MIRAS) radiometer refers to processing the measured raw data up to dual-polarization brightness temperature maps over the earth's surface, which is the level 1 product of the Soil Moisture and Ocean Salinity (SMOS) mission. The process starts with a self-correction of comparators offset and quadrature error and is followed by the calibration procedure itself. This one is based on periodically injecting correlated and uncorrelated noise to all receivers in order to measure their relevant parameters, which are then used to correct the raw data. This can deal with most of the errors associated with the receivers but does not correct for antenna errors, which must be included in the image reconstruction algorithm. Relative S-parameters of the noise injection network and of the input switch are needed as additional data, whereas the whole process is independent of the exact value of the noise source power and of the distribution network physical temperature. On the other hand, the approach relies on having at least one very well-calibrated reference receiver, which is implemented as a noise injection radiometer. The result is the calibrated visibility function, which is inverted by the image reconstruction algorithm to get the brightness temperature as a function of the director cosines at the antenna reference plane. The final step is a coordinate rotation to obtain the horizontal and vertical brightness temperature maps over the earth. The procedures presented are validated using a complete SMOS simulator previously developed by the authors.
10 February 2011 in IEEE Transactions on Geoscience and Remote Sensing
After the successful launching of the Soil Moisture and Ocean Salinity satellite in November 2009, continuous streams of data started to be regularly downloaded and made available to be processed. The first six months of operation were fully dedicated to the In-Orbit Commissioning Phase, with an intense activity aimed at bringing the satellite and instrument into a fully operational condition. Concerning the payload Microwave Imaging Radiometer with Aperture Synthesis, it was fully characterized using specific orbits dedicated to check all instrument modes. The procedures, already defined during the on-ground characterization, were repeated so as to obtain realistic temperature characterization and updated internal calibration parameters. External calibration maneuvers were tested for the first time and provided absolute instrument calibration, as well as corrections to internal calibration data. Overall, performance parameters, such as stability, radiometric sensitivity and radiometric accuracy were evaluated. The main results of this activity are presented in this paper, showing that the instrument delivers stable and well-calibrated data thanks to the combination of external and internal calibration and to an accurate thermal characterization. Finally, the quality of the visibility calibration is demonstrated by producing brightness temperature images in the alias-free field of view using standard inversion techniques. Images of ocean, ice, and land are given as examples.
14 June 2004 in IEEE Transactions on Geoscience and Remote Sensing
The Microwave Imaging Radiometer by Aperture Synthesis (MIRAS) is the single payload of the European Space Agency's (ESA) Soil Moisture and Ocean Salinity (SMOS) Earth Explorer Opportunity mission. MIRAS will be the first two-dimensional aperture synthesis radiometer for Earth observation. Two-dimensional aperture synthesis radiometers can generate brightness temperature images by a Fourier synthesis process without mechanical antenna steering. To do so and have the necessary wide swath for Earth observation, the array is formed by small and low directive antennas, which do not attenuate enough bright noise sources that may interfere with the measurements. This study analyzes the impact of the radio-frequency emission from the Sun in the SMOS mission, reviews the basic image reconstruction algorithms, and proposes a technique to minimize Sun effects.
Soil moisture and ocean salinity at surface level can be measured by passive microwave remote sensing at L‐band. To provide global coverage data of soil moisture and ocean salinity with three‐day revisit time, the Earth Explorer Opportunity Mission SMOS (Soil Moisture and Ocean Salinity) was selected by ESA (European Space Agency) in May 1999. SMOS' single payload is a Y‐shaped 2‐D aperture synthesis interferometric radiometer called MIRAS (Microwave Imaging Radiometer by Aperture Synthesis). SMOS presents some particular imaging peculiarities: variation of incidence and azimuth angles, different radiometric sensitivity and accuracy at each direction (pixels), and geometric polarization mixing. Therefore, the accuracy of the geophysical parameter retrieval depends on the knowledge of the angular dependence of the emissivity over a wide range of incidence and azimuth angles. The accuracy of the sea surface salinity retrievals depends on our capability to correct the wind‐induced variation of the brightness temperatures. To better understand wind effects, ESA sponsored the WInd and Salinity Experiment 2000 (WISE‐2000) from November 15, 2000, to January 16, 2001, in the Casablanca oil rig, at 40 km off the coast of Tarragona (Spain). This paper is divided into two parts. First, it presents the derived sensitivities of the brightness temperatures at vertical and horizontal polarizations with wind speed, and compares to Hollinger's measurements and numerical simulations. Second, these results are applied to the SMOS sea surface salinity (SSS) retrieval problem for different tracks within the swath. It is shown that, except for low SSS and sea surface temperature (SST), the retrieved SSS has a RMS error of approximately 1 psu in one satellite pass.
18 May 2015 in IEEE Geoscience and Remote Sensing Letters
Land-sea contamination observed in Soil Moisture and Ocean Salinity (SMOS) brightness temperature images is found to have two main contributions: the floor error inherent of image reconstruction and a multiplicative error either in the antenna temperature or in the visibility samples measured by the correlator. The origin of this last one is traced down to SMOS calibration parameters to yield a simple correction scheme, which is validated against several geophysical scenarios. Autoconsistency rules in interferometric synthesis together with redundant and complementary calibration procedures provide a robust SMOS calibration scheme.