The introduction of long-chain branches (LCBs) in polypropylene (PP) during the extrusion process is normally induced by peroxide chemicals which are known to lead to the formation of secondary products in the resin. Here we report a novel synthesis method to prepare LCB-PP via in situ ozonolysis during reactive extrusion in the presence of a multifunctional agent. Depending on the fast ozonation of molten PP molecules, free radicals can be generated in PP macromolecules and induce chain scission reactions during extrusion. LCB structures of PP could be formed when a multifunctional agent, trimethylolpropane triacrylate (TMPTA), was added into the PP matrix during extrusion. The effect of reaction temperature, polymer flow rate and TMPTA concentration on the LCB-PP structures is discussed. Molecular parameters of LCB-PP were detected by MALS SEC technique. Various rheological plots including elongation rheological properties were applied to distinguish the LCB structures in PP samples. Without residues and by-products of peroxide in the final polymer resin, this synthesis method of LCB-PP has highly efficient and easily adjustable merits.
Various quantities of carbon fibers (CFs) (from 5% to 20% in weight) were added to matrix by melt blending to produce polylactic acid (PLA)/thermoplastic polyurethane (TPU)/CF composites. Differential scanning calorimetry measurements revealed that the CF content and mixing time had little influence on the crystallization and melting behavior of PLA. Thermogravimetric analysis showed that the introduction of CFs tended to decrease the thermal stability of PLA/TPU/CF composites, and the increase of mixing time tended to increase the thermal stability of PLA/TPU/CF composites when the mixing time is <5 min. Rheological results showed that all the samples exhibited non-Newtonian and shear thinning characteristics. The storage modulus and complex viscosity both increased with the increase of the CF content. It also showed that the increase of mixing time tended to increase the storage modulus and complex viscosity of PLA/TPU/CF composites when the mixing time is <5 min. Scanning electron microscopy images showed that the TPU/PLA blends contain a continuous PLA phase with evenly distributed TPU particles in the size range of 0.25–3 μm, and the blends are immiscible at the micron scale. Mechanical properties showed that the addition of proper CF content could lead to an obvious increase (about 11.43%) in tensile strength.