Interfaces play a decisive role in perovskite solar cells’ power conversion efficiency and their long‐term durability. Small‐molecule hole‐transporting materials (HTMs) have grabbed enormous attention due to their structural flexibility, material properties, and stabilities, allowing for improved operational durability in perovskite photovoltaics. This study synthesizes and investigates a new class of benzimidazole‐based small molecules, named YJS001 and YJS003, serving as the HTMs to enable high‐efficiency mixed‐cation mixed‐halide perovskite solar cells. The benzimidazole‐based materials are dopant‐free HTMs composed of donor and acceptor building blocks that are designed to engineer the energy level alignment near the HTM/perovskite interface. Mixed‐cation mixed‐halide perovskites can be grown uniformly on both HTMs with large crystalline grains. It is discovered that the donor‐rich YJS003‐based solar cell exhibits a high open‐circuit voltage of 1.09 V with a champion power conversion efficiency of over 20%. Power‐dependent current–voltage characteristics of the solar cells are analyzed, from which the high performance of YJS003's excellent hole mobility and well‐aligned energy level is attributed. This work introduces a new class of benzimidazole‐based small molecules as HTMs, that paves the path for dopant free interface material development for commercialization of perovskite solar cells.
A new series of N-heterocyclic carbene (NHC)-pyridine ruthenium complexes incorporating a carbene unit as an ancillary ligand were designed and successfully synthesized by using simple synthetic methods. The photophysical, electrochemical and photovoltaic properties of these NHC-pyridine based ruthenium complexes were investigated. These complexes showed photoelectric conversion efficiencies in the range of 6.43 ∼ 7.24% under the illumination of AM 1.5 (100 mW cm−2). Interestingly, the modifications on the ancillary ligand of these sensitizers by removal of an alkoxyl group and replacement of the octyl chain with a 3,5-difluorobenzyl group showed a 13% increase in the conversion efficiency for the CifPR dye. These results demonstrated that structural modifications on the NHC-pyridine ancillary ligand of ruthenium complexes results in dye-sensitized solar cells exhibiting a comparable cell performance to that obtained using the standard N719 dye.
Dye‐sensitized solar cells (DSSCs) based on a TiO2 photoanode have been considered as an alternative source in the field of renewable energy resources. In DSSCs, photoanode plays a key role to achieve excellent photo‐to‐electric conversion efficiency. The surface morphology, surface area, TiO2 crystal phase, and the dispersion of TiO2 nanoparticles are the most important factors influencing the properties of a photoanode. The smooth TiO2 surface morphology of the photoanode indicates closely packed arrangement of TiO2 particles which enhance the light harvesting efficiency of the cell. In this paper, a smooth TiO2 photoanode has been successfully prepared using a well‐dispersed anatase TiO2 nanosol via a simple hydrothermal process. The above TiO2 photoanode was then compared with the photoanode made from commercial TiO2 nanoparticle pastes. The morphological and structural analyses of both the aforementioned photoanodes were comprehensively characterized by scanning electron microscopy and X‐ray diffraction analysis. The DSSC fabricated by using a‐TiO2 nanosol‐based photoelectrode exhibited an overall light conversion efficiency of 7.20% and a short‐circuit current density of 13.34 mA cm−2, which was significantly higher than those of the DSSCs with the TiO2 nanoparticles‐based electrodes.