Here we show that when the temperature exceeded 1200 °C, the tensile strength drops sharply with change of fracture mode from fiber pull-out to fiber-break. Theoretical analysis indicates that the reduction of tensile strength and change of fracture mode is due to the variation of residual radial stress on the fiber–matrix interface coating. When the temperature exceeds the preparation temperature of the composites, the residual radial stress on the fiber–matrix interface coating changes from tensile to compressive, leading to the increase of the interface strength with increasing temperature. The fracture behavior of SiC–SiC composites changes from ductile to brittle when the strength of fiber–matrix interface coating exceeds the critical value. Theoretical analysis predicts that the high temperature tensile strength can increase with a decrease in fiber–matrix interface thickness, which is verified by experiments.
31 July 2017 in Journal of Nuclear Engineering and Radiation Science
A finite element method (FEM) is applied to investigate the thermal conductivity of polycrystalline UO2. The influences of microstructure are especially important for UO2 due to the severe structural changes under irradiation conditions. In this study, we have investigated the influences of microstructures on the thermal conductivity of polycrystalline UO2 using FEM. The temperature profile of fuel pellet with different microstructures during service is also investigated. The thermal conductivity increases with increasing grain size. The grain size distribution has obvious influence on the thermal conductivity especially when there are pores in the polycrystal. The influences of porosity and pore size are very sensitive to the position of the pores. The results obtained in this study are useful for the prediction of property changes of UO2 fuel in pile and important to gain some design guidance to tune the properties through the control of the microstructure.