In this study, based on the concrete damaged plasticity (CDP) model in the ABAQUS software, various plastic damage factor calculation methods were introduced to obtain CDP parameters suitable for reactive powder concrete (RPC) materials. Combined with the existing tests for the bending performance of steel-reinforced RPC beams, the CDP parameters of the RPC material were input into ABAQUS to establish a finite element model considering the bond and slip between the steel and RPC for numerical simulation. The load-deflection curve obtained by the simulation was compared with the measured curve in the experiment. The results indicated that on the basis of the experimentally measured RPC material eigenvalue parameters, combined with the appropriate RPC constitutive relationship and the calculation method of the plastic damage factor, the numerical simulation results considering the bond-slip were in good agreement with the experimental results with a deviation of less than 10%. Thus, it is recommended to select a gentle compressive stress-strain curve in the descending section, an approximate strengthening model of the tensile stress-strain curve, and to use the energy loss method and Sidoroff’s energy equivalence principle to calculate the RPC plastic damage parameters.

Liquefaction and earthquake damage to coral sand sites can cause engineering structure failure. Both testing and analyzing the seismic response characteristics of pile groups on coral sand sites are highly important for the seismic design of engineering structures. To address the lack of research on the seismic dynamic response of group pile foundations in coral sand sites, this study analyzes the characteristics of the seismic dynamic response of vertical and batter pile foundations for bridges in coral sand liquefaction foundations via the shaking table model test and investigates the variation patterns of acceleration, excess pore water pressure (EPWP), and the bending moment and displacement of foundations, soil, and superstructures under different vibration intensities. Results show that the excitation wave type significantly affects liquefaction: at 0.1 g of peak acceleration, only high-frequency sine wave tests liquefied, with small EPWP ratios, while at 0.2 g, all tests liquefied. Vertical pile foundations had lower soil acceleration than batter piles due to differences in bearing mechanisms. Before liquefaction, batter piles had smaller EPWP ratios but experienced greater bending moments under the same horizontal force. Overall, batter piles showed higher dynamic stability and anti-tilt capabilities but endured larger bending moments compared to vertical piles in coral sand foundations. In conclusion, batter pile foundations demonstrate superior seismic performance in coral sand sites, offering enhanced stability and resistance to liquefaction-induced failures.