The impact of storage temperature (4, 22 and 37 °C) and storage time (7, 14 and 21 days) on anaerobic digestion inocula was investigated through specific methanogenic activity assays. Experimental results showed that methanogenic activity decreased over time with storage, regardless of storage temperature. However, the rate at which the methanogenic activity decreased was two and five times slower at 4 °C than at 22 and 37 °C, respectively. The inoculum stored at 4 °C and room temperature (22 °C) maintained methanogenic activity close to that of fresh inoculum for 14 days (<10% difference). However, a storage temperature of 4 °C is preferred because of the slower decrease in activity with lengthier storage time. From this research, it was concluded that inoculum storage time should generally be kept to a minimum, but that storage at 4 °C could help maintain methanogenic activity for longer.

Accurate determination of biochemical methane potential (BMP) is important for both biogas research and practice. However, access to laboratory equipment limits the capacity of small laboratories or biogas plants to conduct reliable BMP assays, especially in low- and middle-income countries. This paper describes the development and validation of a new gas density-based method for measuring BMP (GD-BMP). In the GD-BMP method, biogas composition is determined from biogas density. Biogas density is based on bottle mass loss and biogas volume, and these can be accurately measured using only a standard laboratory scale, inexpensive syringes, and a simple manometer. Results from four experiments carried out in three different laboratories showed that the GD-BMP method is both accurate (no significant bias compared to gravimetric or volumetric methods with biogas analysis by gas chromatography) and precise (<3% relative standard deviation is possible). BMP values from the GD-BMP method were also comparable to those measured for the same substrates with an industry standard automated system (AMPTS II) in two independent laboratories (maximum difference 10%). Additionally, the GD-BMP method was shown to be accurate even in the presence of leakage by excluding leakage from mass loss measurements. The proposed GD-BMP method represents a significant breakthrough for both biogas research and the industry. With it, accurate BMP measurement is possible with only a minimal investment in supplies and equipment.