The precipitation of magnesium hydroxy-carbonate hydrates has been suggested as a route to sequester CO2 into solids. We report the development of self-cementing compositions based on nesquehonite, MgCO3·3H2O, that are made from CO2-containing gas streams, the CO2 being separated from other gases by its high solubility in alkaline water, while magnesium is typically provided by waste desalination brines. Precipitation conditions are adjusted to optimize the formation of nesquehonite and the crystalline solid can readily be washed free of chloride. Products can be prepared to achieve self-cementation following two routes: (i) thermal activation of the nesquehonite then rehydration of the precursor or (ii) direct curing of a slurry of nesquehonite. The products thus obtained contain ~ 30 wt% CO2 and could form the basis for a new generation of lightweight, thermally insulating boards, blocks and panels, with sufficient strength for general construction.
The production of Portland cement accounts for approximately 7% of global anthropogenic CO2 emissions. Carbon CAPture and CONversion (CAPCON) technology under development by the authors allows for new methods to be developed to offset these emissions. Carbon-negative Precipitated Calcium Carbonate (PCC), produced from CO2 emissions, can be used as a means of offsetting the carbon footprint of cement production while potentially providing benefits to cement hydration, workability, durability and strength. In this paper, we present preliminary test results obtained for the mechanical and chemical properties of a new class of PCC blended Portland cements. These initial findings have shown that these cements behave differently from commonly used Portland cement and Portland limestone cement, which have been well documented to improve workability and the rate of hydration. The strength of blended Portland cements incorporating carbon-negative PCC Admixture (PCC-A) has been found to exceed that of the reference baseline—Ordinary Portland Cement (OPC). The reduction of the cement clinker factor, when using carbon-negative PCC-A, and the observed increase in compressive strength and the associated reduction in member size can reduce the carbon footprint of blended Portland cements by more than 25%.