To gain better insight into the thermal state and composition of the lithospheric mantle beneath the Upper Muna kimberlite field (Siberian craton), a suite of 323 clinopyroxene xenocrysts and 10 mantle xenoliths from the Komsomolskaya-Magnitnaya (KM) pipe have been studied. We selected 188 clinopyroxene grains suitable for precise pressure (P)-temperature (T) estimation using single-clinopyroxene thermobarometry. The majority of P-T points lie along a narrow, elongated field in P-T space with a cluster of high-T and high-P points above 1300 °C, which deviates from the main P-T trend. The latter points may record a thermal event associated with kimberlite magmatism (a “stepped” or “kinked” geotherm). In order to eliminate these factors, the steady-state mantle paleogeotherm for the KM pipe at the time of initiation of kimberlite magmatism (Late Devonian–Early Carboniferous) was constrained by numerical fitting of P-T points below T = 1200 °C. The obtained mantle paleogeotherm is similar to the one from the nearby Novinka pipe, corresponding to a ~34–35 mW/m2 surface heat flux, 225–230 km lithospheric thickness, and 110–120 thick “diamond window” for the Upper Muna field. Coarse peridotite xenoliths are consistent in their P-T estimates with the steady-state mantle paleogeotherm derived from clinopyroxene xenocrysts, whereas porphyroclastic ones plot within the cluster of high-T and high-P clinopyroxene xenocrysts. Discrimination using Cr2O3 demonstrates that peridotitic clinopyroxene xenocrysts are prevalent (89%) among all studied 323 xenocrysts, suggesting that the Upper Muna mantle is predominantly composed of peridotites. Clinopyroxene-poor or -free peridotitic rocks such as harzburgites and dunites may be evident at depths of 140–180 km in the Upper Muna mantle. Judging solely from the thermal considerations and the thickness of the lithosphere, the KM and Novinka pipes should have excellent diamond potential. However, all pipes in the Upper Muna field have low diamond grades (<0.9, in carats/ton), although the lithosphere thickness is almost similar to the values obtained for the high-grade Udachnaya and Mir pipes from the Daldyn and Mirny fields, respectively. Therefore, other factors have affected the diamond grade of the Upper Muna kimberlite field.
Results of experimental study at 7.0–8.5 GPa and 1300–1900°C of the systems pyrope Mg3Al2Si3O12 (Prp)-Na2MgSi5O12 (NaGrt) modeling solid solutions of Na-bearing garnets, Prp-jadeite NaAlSi2O6 (Jd) in a simplified mode demonstrating melting relations of Na-rich eclogite, and Prp-Na2CO3 are presented. Prp-Na2MgSi5O12 join is a pseudobinary that results from the decomposition of NaGrt on to coesite and Na-pyroxene. Synthesized garnets are characterized by Na admixture (>0.32 wt % Na2O) and excess Si (3.05–3.15 f.u.). Maximal Na2O concentrations (1.5 wt % Na2O) are reached on the solidus of the system at 8.5 GPa. Clear correlation between Na and Si was established in synthesized garnets; this provides evidence for heterovalent isomorphism of the Mg + Al → Na + Si type with the appearance of Na2MgSi5O12 component as a mechanism of such garnet formation. The Prp-Jd join is also pseudobinary that results from the formation of two series of solid solutions: (1) garnet (Prp-NaGrt-majorite) and (2) pyroxene (Jd-clinoenstatite-Eskola molecule), and the appearance of kyanite at the solidus of the system, where garnets with the highest Na2O contents (>0.8 wt %) are formed. In spite of quite a wide field of garnet crystallization (20–100 mol % Prp), garnets with significant sodium concentration (>0.3 wt % Na2O) are formed in a Jd-rich part of the system (20–50 mol % Prp). In the Prp-Na2CO3 system at 8.5 GPa garnet crystallizes in a wide range of starting compositions as a liquidus mineral containing up to 0.9 wt % Na2O. Our experiments demonstrate that melt alkalinity, as well as PT-parameters control the crystallization of Na-bearing majoritic garnets. The results obtained provide evidence for the fact that the majority of natural diamonds with inclusions of Na-bearing majoritic garnets containing <0.4 wt % Na2O were formed in alkaline silicate (carbonate-silicate) melts at a pressure of 1 wt % Na2O) could be formed at a pressure of >8.5 GPa. 1 This article was translated by the authors.
The results of study secondary crystallized melt inclusions in olivine of a sheared peridotite xenolith from the Komsomolskaya–Magnitnaya kimberlite pipe (Upper Muna field, Yakutia) are reported. Monticellite, phlogopite, tetraferriphlogopite KMg3(Fe3+)Si3O10(F,Cl,OH), apatite, aphthitalite K3Na(SO4)2, burkeite Na6CO3(SO4)2, and carbonates, namely calcite, nyerereite (Na,K)2Ca(CO3)2, shortite Na2Ca2(CO3)3, and eitelite Na2Mg(CO3)2, were detected among the daughter minerals of the melt inclusions by the method of confocal Raman spectroscopy. The abundance of alkali carbonates in the inclusions indicates the alkali–carbonate composition of the melt. Previously, identical inclusions of alkali–carbonate melt were reported in olivine of sheared peridotites from the Udachnaya pipe (Daldyn field). Melt inclusions in sheared peridotites are the relics of a crystallized kimberlite melt that penetrated into peridotites either during the transport of xenoliths to the surface or directly in the mantle shortly prior to the entrapment of xenoliths by the kimberlite magma. If the second scenario took place, the finds of alkali–carbonate melt inclusions in sheared peridotites carried from different mantle depths in the Udachnaya and Komsomolskaya–Magnitnaya kimberlite pipes indicate a large-scale metasomatic alteration of the lithospheric mantle of the Siberian Craton by alkaline-carbonate melts, which preceded the kimberlite magmatism. However, regardless of which of the two models proposed above is correct, the results reported here support the alkali–carbonate composition of primary kimberlite melts.