Automotive engineering design has recently focused majorly on the stress analysis and optimization of a connecting rod with keen emphases to the vital parameters such as deformation, stress, fatigue and strain, factor safety, life values among others. The performance of a connecting rod in an automobile engine is influenced by its design and weight. Hence, for the production of a durable, cheaper and lightweight connecting rod, analysis and optimization become necessary. This article provides a review of some vital work done by various researchers in designing, analyzing and optimization of connecting rod of an engine using Finite element analysis in ANSYS workbench A comprehensive comparison table and graphs for the reviewed research articles have been provided. The article will serve as a stepping stone for both old and new researchers in the field of automotive design.
1 September 2018 in International Journal of Power Electronics and Drive Systems (IJPEDS)
This paper aims to develop a new mobile robot path planning algorithm, called generalized laser simulator (GLS), for navigating autonomously mobile robots in the presence of static and dynamic obstacles. This algorithm enables a mobile robot to identify a feasible path while finding the target and avoiding obstacles while moving in complex regions. An optimal path between the start and target point is found by forming a wave of points in all directions towards the target position considering target minimum and border maximum distance principles. The algorithm will select the minimum path from the candidate points to target while avoiding obstacles. The obstacle borders are regarded as the environment’s borders for static obstacle avoidance. However, once dynamic obstacles appear in front of the GLS waves, the system detects them as new dynamic obstacle borders. Several experiments were carried out to validate the effectiveness and practicality of the GLS algorithm, including path-planning experiments in the presence of obstacles in a complex dynamic environment. The findings indicate that the robot could successfully find the correct path while avoiding obstacles. The proposed method is compared to other popular methods in terms of speed and path length in both real and simulated environments. According to the results, the GLS algorithm outperformed the original laser simulator (LS) method in path and success rate. With application of the all-direction border scan, it outperforms the A-star (A*) and PRM algorithms and provides safer and shorter paths. Furthermore, the path planning approach was validated for local planning in simulation and real-world tests, in which the proposed method produced the best path compared to the original LS algorithm.
Multi‐level inverters are widely used in high‐voltage and high‐power applications due to the increasing demand for renewable energy. This study proposes a novel single‐phase reduced switch multi‐level inverter topology that generates 11 levels of output voltage steps, operates in asymmetric mode, and uses fewer power electronic switches with efficient switching control. To optimize the inverter's performance, Moth Flame Optimization (MFO), Particle Swarm Optimization (PSO), and Whale Optimization Technique (WOA) are utilized to apply the selective harmonic elimination technique. The proposed circuit is implemented in PSIM software using optimized switching angles, and the fitness functions and switching angles for the three optimizers are evaluated and reported. The inverter's performance at optimal modulation points for the three optimizers is computed and analyzed, with the Total Harmonic Distortion (THD) measured at 0.82 modulation point before and after filtering. Results show that MFO outperforms PSO and WOA with the lowest THD values of 0.85% and 0.78%, respectively; therefore, complying with the IEEE 519 standard. The experimental validation of MFO's superiority is performed using the Typhoon HIL‐402 hardware device. This study provides a promising solution for the design and optimization of multi‐level inverters, paving the way for more efficient and reliable renewable energy systems.