Angel Garcia Martino

Mr. Angel Garcia Martino

orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 April 2020 in Metals
Verified
Journal Article
Open access
PDF file
AMAngel Garcia Martino
Angel Garcia Martino
CMCesar Menénedez
Cesar Menénedez
Maria Manuela Prieto GonzalezMaria Manuela Prieto Gonzalez
Maria Manuela Prieto Gonzalez
Jose DiazJose Diaz
Jose Diaz
The classical thermal cycle in a Hot Dip Galvanizing (HDG) line has four steps: heating, soaking, cooling, and aging. The furnace of an ArcelorMittal HDG line was revamped to increase its heating capacity. This new configuration without the soaking step led to the redefinition of the thermal cycles for all the steel grades, especially for High Strength Low Alloyed (HSLA) steels, where it was necessary to define a new control parameter based on time and temperature. This paper presents the work done to improve the control of the mechanical properties of HSLA steels in the HDG line. Four different types of numerical models (linear and polynomial regressions, artificial neural networks, and Multivariate Adaptive Regression Splines), are applied to predict the yield strength and the tensile strength of individual coils. It is concluded that the introduction of the time–temperature parameter improves the accuracy of the predictions over 10% in most of the cases. An additional improvement is obtained with the use of the process values corresponding to the sampling area instead of the coil average ones. The use of these models makes it possible, if necessary, to adjust individually the presets of the coils before processing them in the galvanizing line and reduce the scattering of the mechanical properties.

11 February 2020 in Metallurgical Research & Technology
Verified
Journal Article
Closed access
PDF file
AMAngel Garcia Martino
Angel Garcia Martino
MPMaría Manuela Prieto
María Manuela Prieto
Modeling of vertical radiant tube annealing furnaces has proven to be one of the best tools to improve the performance of a galvanizing line. However, there is a lack of a practical model able to consider the temperature and status of the radiant tubes, which are key elements in the capacity of the furnace. The model proposed divides the furnace in several segments and compares the radiated heat, that is exchanged between the radiant tubes and the strip, and the heat required to increase the temperature of the mass flow on the strip. This comparison is represented as an implicit equation where the strip's temperature is obtained by iteration. The model is validated calculating the final temperature of more than five hundred coils divided in four different steel families. The 90% of the calculated temperatures are within a 2% deviation range compared to the measured temperatures. This model combines good accuracy in the results with low computational times, allowing the simulation of hundreds of coils in a few minutes.

9 May 2019 in Ironmaking & Steelmaking: Processes, Products and Applications
Verified
Journal Article
Closed access
AMAngel Garcia Martino
Angel Garcia Martino
SFSantos Fernández
Santos Fernández
JSJesús Santiago
Jesús Santiago
MPMaria Manuela Prieto
Maria Manuela Prieto
This paper describes the results of the investigations done to adapt the thermal cycles applied to High Strength Low Alloy (HSLA) steels to the new furnace configuration of a galvanizing line. During the revamping of a hot dip galvanizing line, new radiant tubes were installed in the soaking furnace with the purpose of increasing the line capacity. This modification eliminated the soaking stage and forced to redesign the thermal cycles of the furnace. As the classical cycles proposed for the HSLAs worrisomely increased the percentage of rejections, it was defined a new control parameter based on the strip thickness, time in the furnace and strip temperature to guarantee the mechanical characteristics of these steels.