The misuse of antibiotics as well as incorrect dosage or insufficient time for detoxification can result in the presence of pharmacologically active molecules in fresh milk. Hence, in many countries, commercially available milk has to be tested with immunological, chromatographic or microbiological analytical methods to avoid consumption of antibiotic residues. Here a novel, sensitive and portable assay setup for the detection and quantification of penicillin and kanamycin in whole fat milk (WFM) based on competitive magnetic immunodetection (cMID) is described and assay accuracy determined. For this, penicillin G and kanamycin-conjugates were generated and coated onto a matrix of immunofiltration columns (IFC). Biotinylated penicillin G or kanamycin-specific antibodies were pre-incubated with antibiotics-containing samples and subsequently applied onto IFC to determine the concentration of antibiotics through the competition of antibody-binding to the antibiotic-conjugate molecules. Bound antibodies were labeled with streptavidin-coated magnetic particles and quantified using frequency magnetic mixing technology. Based on calibration measurements in WFM with detection limits of 1.33 ng·mL−1 for penicillin G and 1.0 ng·mL−1 for kanamycin, spiked WFM samples were analyzed, revealing highly accurate recovery rates and assay precision. Our results demonstrate the suitability of cMID-based competition assay for reliable and easy on-site testing of milk.
Food and crop contaminations with mycotoxins are a severe health risk for consumers and cause high economic losses worldwide. Currently, different chromatographic- and immuno-based methods are used to detect mycotoxins within different sample matrices. There is a need for novel, highly sensitive detection technologies that avoid time-consuming procedures and expensive laboratory equipment but still provide sufficient sensitivity to achieve the mandated detection limit for mycotoxin content. Here we describe a novel, highly sensitive, and portable aflatoxin B1 detection approach using competitive magnetic immunodetection (cMID). As a reference method, a competitive ELISA optimized by checkerboard titration was established. For the novel cMID procedure, immunofiltration columns, coated with aflatoxin B1-BSA conjugate were used for competitive enrichment of biotinylated aflatoxin B1-specific antibodies. Subsequently, magnetic particles functionalized with streptavidin can be applied to magnetically label retained antibodies. By means of frequency mixing technology, particles were detected and quantified corresponding to the aflatoxin content in the sample. After the optimization of assay conditions, we successfully demonstrated the new competitive magnetic detection approach with a comparable detection limit of 1.1 ng aflatoxin B1 per mL sample to the cELISA reference method. Our results indicate that the cMID is a promising method reducing the risks of processing contaminated commodities.
A novel severe acute respiratory syndrome coronavirus-2 (SARS-CoV-2) emerged in China in December 2019, causing an ongoing, rapidly spreading global pandemic. Worldwide, vaccination is now expected to provide containment of the novel virus, resulting in an antibody-mediated immunity. To verify this, serological antibody assays qualitatively as well as quantitatively depicting the amount of generated antibodies are of great importance. Currently available test methods are either laboratory based or do not have the ability to indicate an estimation about the immune response. To overcome this, a novel and rapid serological magnetic immunodetection (MID) point-of-care (PoC) assay was developed, with sensitivity and specificity comparable to laboratory-based DiaSorin Liaison SARS-CoV-2 S1/S2 IgG assay. To specifically enrich human antibodies against SARS-CoV-2 in immunofiltration columns (IFCs) from patient sera, a SARS-CoV-2 S1 antigen was transiently produced in plants, purified and immobilized on the IFC. Then, an IgG-specific secondary antibody could bind to the retained antibodies, which was finally labeled using superparamagnetic nanoparticles. Based on frequency magnetic mixing technology (FMMD), the magnetic particles enriched in IFC were detected using a portable FMMD device. The obtained measurement signal correlates with the amount of SARS-CoV-2-specific antibodies in the sera, which could be demonstrated by titer determination. In this study, a MID-based assay could be developed, giving qualitative as well as semiquantitative results of SARS-CoV-2-specific antibody levels in patient’s sera within 21 min of assay time with a sensitivity of 97% and a specificity of 92%, based on the analysis of 170 sera from hospitalized patients that were tested using an Food and Drug Administration (FDA)-certified chemiluminescence assay.
SARS-CoV-2 causes ongoing infections worldwide, and identifying people with immunity is becoming increasingly important. Available point-of-care diagnostic systems as lateral flow assays have high potential for fast and easy on-site antibody testing but are lacking specificity, sensitivity or possibility for quantitative measurements. Here, a new point-of-care approach for SARS-CoV-2 specific antibody detection in human serum based on magnetic immuno-detection is described and compared to standard ELISA. For magnetic immuno-detection, immunofiltration columns were coated with a SARS-CoV-2 spike protein peptide. SARS-CoV-2 peptide reactive antibodies, spiked at different concentrations into PBS and human serum, were rinsed through immunofiltration columns. Specific antibodies were retained within the IFC and labelled with an isotype specific biotinylated antibody. Streptavidin-functionalized magnetic nanoparticles were applied to label the secondary antibodies. Enriched magnetic nanoparticles were then detected by means of frequency magnetic mixing detection technology, using a portable magnetic read-out device. Measuring signals corresponded to the amount of SARS-CoV-2 specific antibodies in the sample. Our preliminary magnetic immuno-detection setup resulted in a higher sensitivity and broader detection range and was four times faster than ELISA. Further optimizations could reduce assay times to that of a typical lateral flow assay, enabling a fast and easy approach, well suited for point-of-care measurements without expensive lab equipment.
Foodborne zoonotic pathogens have a severe impact on food safety. The demand for animal-based food products (meat, milk, and eggs) is increasing, and therefore faster methods are necessary to detect infected animals or contaminated food before products enter the market. However, conventional detection is based on time-consuming microbial cultivation methods. Here, the establishment of a quorum sensing-based method for detection of foodborne pathogens as Yersinia enterocolitica in a co-cultivation approach using a bacterial biosensor carrying a special sensor plasmid is described. We combined selective enrichment with the simultaneous detection of pathogens by recording autoinducer-1-induced bioluminescent response of the biosensor. This new approach enables real-time detection with a calculated sensitivity of one initial cell in a sample after 15.3 h of co-cultivation, while higher levels of initial contamination can be detected within less than half of the time. Our new method is substantially faster than conventional microbial cultivation and should be transferrable to other zoonotic foodborne pathogens. As we could demonstrate, quorum sensing is a promising platform for the development of sensitive assays in the area of food quality, safety, and hygiene.