Divya Somvanshi

Dr. Divya Somvanshi


Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 July 2024 in Nature Nanotechnology
Verified
Journal Article
Closed access
PDF file
RPRahul Pendurthi
Rahul Pendurthi
NSNajam U Sakib
Najam U Sakib
MSMuhtasim Ul Karim Sadaf
Muhtasim Ul Karim Sadaf
ZZZhiyu Zhang
Zhiyu Zhang
YSYongwen Sun
Yongwen Sun
SDSaptarshi Das
Saptarshi Das

6 November 2024 in Nature Electronics
Verified
Journal Article
Closed access
PDF file
MDMayukh Das
Mayukh Das
DSDipanjan Sen
Dipanjan Sen
NSNajam U Sakib
Najam U Sakib
HRHarikrishnan Ravichandran
Harikrishnan Ravichandran
YSYongwen Sun
Yongwen Sun
SDSaptarshi Das
Saptarshi Das

15 November 2017 in Physical Review B
Verified
Journal Article
Closed access
PDF file
DSDivya Somvanshi
Divya Somvanshi
SKSangeeth Kallatt
Sangeeth Kallatt
CVChenniappan Venkatesh
Chenniappan Venkatesh
SNSmitha Nair
Smitha Nair
GGGarima Gupta
Garima Gupta
KMKausik Majumdar
Kausik Majumdar
Monolayers of transition metal dichalcogenides (TMDCs) exhibit excellent electronic and optical properties. However, the performance of these two-dimensional (2D) devices are often limited by the large resistance offered by the metal contact interface. To date, the carrier injection mechanism from metal to 2D TMDC layers remains unclear, with widely varying reports of Schottky barrier height (SBH) and contact resistance (Rc), particularly in the monolayer limit. In this paper, we use a combination of theory and experiments in Au and Ni contacted monolayer MoS2 device to elucidate the following points: (i) the carriers are injected at the source contact through a cascade of two potential barriers—the barrier heights being determined by the degree of interaction between the metal and the TMDC layer; (ii) the conventional Richardson equation becomes invalid due to the multidimensional nature of the injection barriers, and using Bardeen-Tersoff theory, we derive the appropriate form of the Richardson equation that describes such a composite barrier; (iii) we propose a novel transfer length method (TLM) based SBH extraction methodology, to reliably extract SBH by eliminating any confounding effect of temperature dependent channel resistance variation; (iv) we derive the Landauer limit of the contact resistance achievable in such devices. A comparison of the limits with the experimentally achieved contact resistance reveals plenty of room for technological improvements.

25 December 2015 in IEEE Transactions on Nanotechnology
Verified
Journal Article
Closed access
GRGopal Rawat
Gopal Rawat
DSDivya Somvanshi
Divya Somvanshi
HKHemant Kumar
Hemant Kumar
YKYogesh Kumar
Yogesh Kumar
CKChandan Kumar
Chandan Kumar
Satyabrata JitSatyabrata Jit
Satyabrata Jit
This paper reports a comparative study of the ultraviolet (UV) detection properties of n-TiO 2 /p-Si heterojunction devices fabricated using two different deposition techniques namely the electron-beam evaporation (EBE) and sol-gel (SG) methods. A systematic study has also been carried out to investigate the structural, electrical, and optical properties of the as deposited TiO 2 thin films on p-Si substrates by the EBE and SG methods. The electrical parameters of both the n-TiO 2 /p-Si heterojunction photodiodes have been measured and compared under dark and UV illumination conditions. The SG based n-TiO 2 /p-Si heterojunction photodiodes are observed with an excellent contrast ratio of ~83911 at -5.2 V bias voltage, which is ~6445 times higher than the EBE-based device. The measured responsivities of the EBE and SG based devices are ~0.69 and ~1.25 A/W at a bias voltage of -10 V (P opt = 650 μW and λ = 365 nm), respectively. Thus, the n-TiO 2 /p-Si heterojunction diodes with SG derived TiO 2 films are considered to be a better choice over the EBE-based n-TiO 2 /p-Si diodes for UV detection applications.

10 September 2013 in IEEE Electron Device Letters
Verified
Journal Article
Closed access
DSDivya Somvanshi
Divya Somvanshi
Satyabrata JitSatyabrata Jit
Satyabrata Jit
This letter reports the temperature-dependent electrical parameters of Pd/n-ZnO thin film-based Schottky diodes grown on n-Si substrates by thermal evaporation method. The parameters have been investigated by considering a Gaussian distributed barrier height across the Pd/n-ZnO interface with a standard deviation σ0 around a mean barrier height qφB,m. As compared with the reported results, the estimated values of the Richardson constant (~19.54Acm-2K-2) and mean barrier height (~1.41 eV) are much closer to their theoretically predicted values of 32Acm-2K-2 (for me*=0.27 m0) and 1.42 eV (for work function of Pd = 5.12 eV and electron affinity of ZnO = 3.7 eV), respectively.

5 May 2015 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
AYAniruddh Bahadur Yadav
Aniruddh Bahadur Yadav
APAmritanshu Pandey
Amritanshu Pandey
DSDivya Somvanshi
Divya Somvanshi
Satyabrata JitSatyabrata Jit
Satyabrata Jit
High-performance ultraviolet (UV) Schottky photodiodes obtained by growing Pd Schottky contacts on the sol-gel-derived n-ZnO thin films deposited on n-Si substrates have been reported in this paper. The current-voltage (I-V) measurements of the as-fabricated Schottky photodiodes show an excellent room temperature contrast ratio (i.e., the ratio of the current under UV illumination to the dark current) of ~5.332 × 10 3 and responsivity (i.e., the parameter characterizing the sensitivity of the device to the UV light) of ~8.39 A/W at -5 V reverse bias voltage, respectively; when the device is illuminated by an UV source of ~650 μW output power at ~ 365 nm. The measured room temperature contrast ratio and responsivity are believed to be the highest among the reported values in the literature for ZnO thin film-based Schottky photodiodes using sol-gel method.