Coal gasification is the process that produces valuable gaseous mixtures consisting primarily of H2 and CO, which can be used to produce liquid fuel and various kinds of chemicals. The literature shows that the effect of particle size on coal gasification and fusibility of coal ash is not clear. In this study, the gasification kinetics and ash fusibility of three coal samples with different particle size ranges were investigated. Thermogravimetric results of coal under a CO2 atmosphere showed that the whole weight loss process consisted of three stages: the loss of moisture, the release of volatile matter, and char gasification with CO2. Coal is a heterogeneous material containing impurities. Different grinding fineness leads to different liberation degrees for impurities. As for the effect of particle size on TG (thermogravimetry) curves, we found that the final solid residue amount was the largest for the coal sample with the smallest particle size. The Miura-Maki isoconversional model was proved to be appropriate to estimate the activation energy and its value experienced a slow increase when the particle size of raw coal increased. Further, we found that particle size had an important impact on ash fusion temperatures and small particle size resulted in higher ash fusion temperatures.
30 October 2025 in International Journal of Hydrogen Energy
A thermodynamic study on a toluene chemical looping reforming process with six metal oxides was conducted to evaluate the product distribution for selecting an appropriate oxygen carrier with thermodynamic favorability towards high syngas yield. The results show that a suitable operation temperature for most oxygen carriers is 900 °C considering syngas selectivity and solid C formation whether the toluene is fed alone or together with fuel gas. The syngas selectivity of all oxygen carriers decreases with the increasing equivalence ratio, but the decrease degrees are quite different due to their different thermodynamic natures. With the increasing amounts of H2 and CO, the syngas selectivity for various oxygen carriers correspondingly decreases. The addition of CO2 and H2O(g) benefits reducing the solid C formation, whereas the addition of CH4 leads to more solid C being produced. Under the simulated gasification gas atmosphere, a synergetic elimination of solid C and water–gas shift reactions are observed. In terms of syngas selectivity, Mn2O3 possesses the best performance, followed by CaFe2O4 and Fe2O3, but NiO and CuO exhibit the lowest performance. BaFe2O4 presents a high H2 selectivity but a very poor CO selectivity due to the formation of BaCO3, which has a high thermodynamic stability below 1200 °C. Nevertheless, Mn2O3 is more likely to form solid C than feeding toluene alone and has a lower melting point. Considering syngas selectivity, carbon deposit and melting point, CaFe2O4 exhibits the highest performance concerning the tar chemical looping.
10 June 2022 in The Canadian Journal of Chemical Engineering