Processes of mechanical alloying of oxide-dispersion-strengthened reactor pressure-vessel steels by cold high-pressure torsion of a powder mixture of low-stable Fe2O3 (Fe3O4) iron oxides and the bcc...
The subject of the present review consists of summing up our previous results on the study of the relaxation of structure along the way (i) of atomic redistribution—in the form of short-range clustering in binary iron alloys—induced by megaplastic deformation (i.e., of super large value), and (ii) of the dissolution and precipitation of disperse nitrides and carbides in steels and intermetallics in ageing alloys. Within the capacity of the main method of executing megaplastic deformation, along with the practically important milling in ball mills and friction-providing external action, we employed high pressure torsion (HPT) in Bridgman anvils, which permitted the control of the degree, rate, and temperature of deformation action. At the local level of two nearest neighbors (one or two coordination shells in relation to an iron atom) we studied atomic mass transfer, stipulated by generation of a large number of point defects of deformation origin, and conducted a comparison with a case of irradiation by high-energy electrons. We established a change in the direction of phase transformations, as well as anomalous acceleration of the ordering and precipitation of disperse phases upon altering the temperature (T < 0.3Tmelt) and rate of deformation (from 2 × 10−2 to 8 × 10−2 s−1). We also demonstrated the possibility of regulating the ultra-fine-grained structure with solid–solution strengthening and dispersion hardening.
An anomalous deformation-induced dissolution of the intermetallics Ni3Al and Ni3Ti in the matrix of austenitic Fe–Ni–Al(Ti) alloys has been revealed in experiment at cryogenic temperatures (down to 77 K) under rolling and high pressure torsion. The observed phenomenon is explained as the result of migration of deformation-stipulated interstitial atoms from a particle into the matrix in the stress field of moving dislocations. With increasing the temperature of deformation, the dissolution is replaced by the deformation-induced precipitation of the intermetallics, which is accelerated due to a sufficient amount of point defects in the matrix, gained as well in the course of deformation at lower temperatures.
Methods of Mössbauer spectroscopy and electron microscopy have been used to study the effect of the severe plastic deformation by high pressure torsion in Bridgman anvils on the dissolution and...
The effect of severe plastic deformation, namely, high-pressure torsion (HPT) at different temperatures and ball milling (BM) at different time intervals, has been investigated by means of Mössbauer spectroscopy in Fe100–xMnx (x = 4.1, 6.8, 9) alloys. Deformation affects the short-range clustering (SRC) in BCC lattice. Two processes occur: destruction of SRC by moving dislocations and enhancement of the SRC by migration of non-equilibrium defects. Destruction of SRC prevails during HPT at 80–293 K; whereas enhancement of SRC dominates at 473–573 K. BM starts enhancing the SRC formation at as low as 293 K due to local heating at impacts. The efficiency of HPT in terms of enhancing SRC increases with increasing temperature. The authors suppose that at low temperatures, a significant fraction of vacancies are excluded from enhancing SRC because of formation of mobile bi- and tri-vacancies having low efficiency of enhancing SRC as compared to that of mono vacancies. Milling of BCC Fe100–xMnx alloys stabilises the BCC phase with respect to α → γ transition at subsequent isothermal annealing because of a high degree of work hardening and formation of composition inhomogeneity.