The Antarctica is a continent mainly devoted to science with a big amount of sensors located in remote places for biological and geophysical purposes. The data from these sensors need to be sent either to the Antarctic stations or directly to the home country. For the last 15 years, La Salle has been working in the application of HF communications (3–30 MHz) with ionospheric reflection for data collection of remote sensors in Antarctica. We have developed and tested the several types of modulations, the frame structure, the radio-modem, and the antennas for two different scenarios. First, a long-range transequatorial (approximately 12,800 km) and low-power communication system is used as an alternative to satellites, which are often not visible from the poles. This distance is covered with a minimum of four hops with oblique incidence in the ionosphere. Second, a low-power system using near vertical incidence skywave (NVIS) communications provides coverage in a surface of approximately 200–250 km radius, a coverage much longer than any other systems operating in either the VHF or UHF band without the need of line of sight.
Sensor networks have become more popular in recent years, now featuring plenty of options and capabilities. Notwithstanding this, remote locations present many difficulties for their study and monitoring. High-frequency (HF) communications are presented as an alternative to satellite communications, being a low-cost and easy-to-deploy solution. Near vertical incidence skywave (NVIS) technology provides a coverage of approximately 250 km (depending on the frequency being used and the ionospheric conditions) without a line of sight using the ionosphere as a communication channel. This paper centers on the study of the ionosphere and its characteristic waves as two independent channels in order to improve any NVIS link, increasing its robustness or decreasing the size of the node antennas through the appliance of specific techniques. We studied the channel sounding of both the ordinary and extraordinary waves and their respective channels, analyzing parameters such as the delay spread and the channel’s availability for each wave. The frequency instability of the hardware used was also measured. Furthermore, the correlation coefficient of the impulse response between both signals was studied. Finally, we applied polarization diversity and two different combining techniques. These measurements were performed on a single frequency link, tuned to 5.4 MHz. An improvement on the mean bit energy-to-noise power spectral density (Eb/N0) was received and the bit error rate (BER) was achieved. The results obtained showed that the extraordinary mode had a higher availability throughout the day (15% more availability), but a delayed spread (approximately 0.3 ms mean value), similar to those of the ordinary wave. Furthermore, an improvement of up to 4 dB was achieved with the usage of polarization diversity, thus reducing transmission errors.
Every year, the number of Internet of Things devices is growing exponentially. The current Internet of Things technology to support the connectivity of such a huge number of devices is limited by the coverage of the base stations deployed. In case of remote areas without coverage of any operator, the use of a satellite connection is such a high‐cost option. The only alternative option for very remote sensor is high frequency (HF) communications with ionospheric reflection. The HF band (3–30 MHz) with Near Vertical Incidence Skywave allows a large coverage area (up to 250 km) without the need of line of sight. The HF radio links usually need higher power transmissions with larger antennas supported by a mast. In this paper, we explore a new transmission scheme for low‐power transmissions, which is equivalent to use small and low gain HF antennas. We study the performance of several digital modulations using different bandwidths and transmission power. The field tests have been done around the Spanish Antarctic Base at Livingston Island to ensure the availability of the system even in polar areas where the behavior of the ionosphere is quite different from lower latitudes. However, the proposed physical layer fits well with any other remote location that requires low power data communication.
In this paper we present a new communications solution for remote villages in developing countries. The system is based in the Near Vertical Ionospheric Skywave (NVIS) technique, able to achieve coverage areas up to 250 Km without line of sight. It is a low-cost, low-power system that can be easily installed and put into operation. The radio system communicates with a smartphone, where a messaging app is running, so text and low resolution images can be sent without the need of any mobile operator. The system has been tested between one of the Andean communities of the Sacred Valley of Incas in Peru and Urubamba, the nearest city.
24 July 2019 in International Journal of Circuit Theory and Applications
Summary: Although many physical layer solutions have appeared for remote sensors and Internet of things during the recent years, none of them is suited to very remote sensors in areas away from any mobile operator coverage. In that case, a solution on the basis of near vertical incidence skywave (NVIS) with reflection in the ionosphere may be very attractive. Using NVIS, no line of sight is needed and the coverage is much bigger than any other system operating in either the very high frequency (VHF) or ultra high frequency (UHF) band. In this paper, we present a new transmission scheme for very remote sensors using the NVIS transmission technique.
Despite high costs and lengthy deployments, satellite communications have traditionally been used to provide coverage in remote areas. However, given the fact that there is no radio infrastructure available in these areas, Near Vertical Incidence Skywave (NVIS) technology has positioned itself as an attractive alternative to communicate with low-power nodes in remote areas. This type of communication works in the HF frequency range complying with STANAG and MIL-STD standards, which define a physical layer for scenarios that differ from NVIS and low-power communication. The purpose of this paper was to present the definition of a new communication physical layer based on single-carrier frequency-domain equalization (SC-FDE) based on these standards but adapted to the ionospheric communication channel. This physical layer was compared to an OFDM-based layer from a previous study. The experiments performed show that this new approach achieves better results than OFDM in terms of a higher signal quality with a higher specific BER probability. Finally, this layer was also used in the theoretical design of an NVIS gateway to link sensor network devices spanning large-scale remote areas in a secure manner in the context of ubiquitous sensor networks (USN).