We study the photoconductive effect of a p-i-p micro-heater integrated in a microring resonator. Due to the surface state absorption (SSA) and two photon absorption (TPA) of optical wave around 1550 nm, free carriers are generated in the silicon waveguide, leading to the modulation of silicon conductivity and thus the current flowing through it. The current-voltage (I-V) response of the p-i-p diode is dependent on the bias voltage and can be divided into ohmic-law regime and space-charge-limited regime. The resonance peak current is more sensitive to optical power in the ohmic-law regime. Such a phenomenon can also be utilized to monitor the optical power in the waveguide.

The shift strategy of automatic transmission plays a vital role in the smoothness and economy of heavy-duty mining trucks. In this paper, an engine fuel consumption model, a 6 + 2 speed automatic transmission model, and a vehicle resistance model are built in MATLAB. Combined with the development of smart mining technology, the traditional two-parameter economic shift strategy is corrected based on vehicle load and road slope. The dynamic programming optimization algorithm is used to extract the best economical shift strategy under known working conditions to reduce the fuel consumption and the number of shifts. Finally, simulation experiments of the optimized shift strategy by dynamic programming in a typical mine work cycle are carried out. The simulation results show that the engine speed and output torque are maintained in a relatively stable and efficient working range by using the proposed shift strategy. Compared with the traditional two-parameter shift strategy, dynamic programming has advantages in reducing fuel consumption and shift numbers.

In order to improve fuel economy, the number of gears in the hydraulic automatic transmission of heavy-duty mining trucks is continuously increasing. Compared with single-transition shifts, double-transition shifts can optimize the structure of multi-speed transmissions, but the difficulty of control will also increase. In this paper, a dynamic model of a 6 + 2 speed automatic transmission and vehicle powertrain system are built based on the Lagrange method, and the dynamic analysis of the two sets of clutches that make up the double-transition shift are carried out. Since a simulation model of the double-transition shift process is built-in MATLAB/Simulink, the shift jerk and clutch energy loss are used as multi-objective, and the genetic algorithm is used to optimize the simulation. Five strategies for the overlapping time of the clutches are proposed, and simulation experiments and Pareto optimal analysis are carried out, respectively. The simulation results show that the non-overlapping of the two sets of clutch inertia phases in the double-transition shift can effectively reduce the shift jerk. The overlapping of the torque phase and the inertia phase of the other clutch set can control the clutch energy loss at a low level due to using less shift time.

The optimal control of automatic transmission plays an important role in the shifting smoothness and fuel economy of heavy-duty mining trucks. In this paper, a dynamic model of the powertrain system is built to study the clutch pressure control during the shifting process. A linear-quadratic optimal regulator is used to achieve the optimum control pressure of clutches, where shifting jerk and clutch friction loss are chosen to a form quadratic performance index function. Besides, a detailed solution of the linear-quadratic problem with the disturbance matrix in the state equations is provided. This paper also carries out a software simulation and verification of the normal condition (no load without slope) and the extreme condition (full load with maximum slope). Compared with the preset reference trajectory control, the simulation results show that the proposed optimal clutch pressure control can effectively reduce jerk and friction loss during the shifting process and has good robustness to different operating conditions.