Experimental aluminum alloy containing 0.8% Ca, 0.5% Zr, 0.5% Fe and 0.25% Si (wt.%), in the form of a long-length rod 12 mm in diameter was manufactured using an electromagnetic casting (EMC) technique. The extremely high cooling rate during alloy solidification (≈10⁴ K/s) caused the formation of a favorable microstructure in the ingot characterized by a small size of the dendritic cells, fine eutectic particles of Ca-containing phases and full dissolution of Zr in Al the solid solution. Due to the microstructure obtained the ingots possess high manufacturability during cold forming (both drawing and rolling). Analysis of the electrical conductivity (EC) and microhardness of the cold rolled strip and cold drawn wire revealed that their temperature dependences are very close. The best combination of hardness and EC in the cold rolled strip was reached after annealing at 450 °C. TEM study of structure evolution revealed that the annealing mode used leads to the formation of L1₂ type Al₃Zr phase precipitates with an average diameter of 10 nm and a high number density. Experimental wire alloy has the best combination of ultimate tensile strength (UTS), electrical conductivity (EC) (200 MPa and 54.8% IACS, respectively) and thermal stability (up to 450 °C) as compared with alloys based on the Al–Zr and Al– rare-earth metal (REM) systems. In addition, it is shown that the presence of calcium in the model alloy increases the electrical conductivity after cold forming operations (both drawing and rolling).

The effect of Cu and Zr additions and annealing temperature on electrical conductivity and hardness of the Al–1.5 wt.% Mn alloy in the form of as-cast ingots and cold rolled sheets has been investigated. It is shown that due to the formation of low alloyed aluminum solid solution and Al₂₀Cu₂Mn₃ and Al₃Zr (L1₂) phase nanoparticles, the 1.5MnCuZr alloy is superior to the base 1.5Mn alloy both in the hardness (up to two times) and electrical conductivity (up to 30%) after metal processing and annealing. A new alloy can be considered as a replacement for existing 6201 type conductive alloys.