A new compact reconfigurable frequency measurement device, based on interferometry is presented in this letter. The device combines the advantages of reconfigurability and fractal geometry. The interferometer uses a Wilkinson power divider connected to two microstrip delay lines; one of these corresponds to the second iteration of the Hilbert fractal curve. PIN diode switches are properly placed in the fractal delay line to achieve a 3-bit circuit, which operates in the 2.7-4.5-GHz range. The design and simulations presented are done using a full-wave electromagnetic simulator, and the frequency responses of the circuit are then shown and compared to measured results.
26 December 2020 in Journal of Electromagnetic Waves and Applications
A planar sensor designed using the fourth Hilbert fractal curve iteration for solid material characterization at multiple frequencies is reported in this paper. The fractal curve is self-similar with space-filling properties. The Hilbert fractal geometry is used to form a compact resonator, with a multiband frequency response where miniaturization is achieved since a large transmission line length is effectively confined in a limited area. The sensor provides five resonances in the frequency range from 0 to 5 GHz. The resonant frequencies are 0.56, 1.68, 2.72, 3.69 and 4.72 GHz, all used to measure the real permittivity of known samples with a sensitivity of 7, 20, 27, 43 and 50 MHz/permittivity, respectively. The sensor is used to measure dielectric samples with 20 × 20 mm2 areas with several thicknesses. Simulations and measurements demonstrate that the Hilbert fractal geometry can be used to design a multiband planar sensor for solid dielectric material characterization.
18 April 2012 in International Journal of Communication Systems
The use of distribution automation systems has grown significantly in electricity companies in recent years. The main reason for this is the need to have a smarter network, in order to reduce the time of power interruption. For such applications, communication using radio frequency is preferred because this solution is more reliable than 3G/4G and cheaper than fiber optics. In this context, it is of utmost importance to have a more efficient base transceiver station (BTS) that can cover the communication of a larger area. In this paper, the mathematical concepts of an intelligent antenna array, as well as the logical operation of an intelligent radiation system controller, are presented. Such system receives as inputs the geographic coordinates of network elements and automatically feeds an intelligent Yagi–Uda antenna array with the appropriate parameters, in order to optimize the radiation pattern into the desired directions. The presented model uses a stochastic optimization method to automatically achieve a set of optimal electrical parameters to excite the array and efficiently direct its beams in a fully controlled way. Thus, the results obtained indicate that the proposed intelligent scheme allows the energy optimization of the antenna system, reducing in 61% the number of BTS needed to cover the same area, when compared to traditional collinear antenna systems.
1 February 2014 in International Journal of Applied Electromagnetics and Mechanics
This paper presents a switched smart antenna system, designed to provide a reliable communication between a Center for Integrated Operation of a distributor of electric power and automation devices such as electrical switches remotely controlled. The smart antenna system is controlled by an electronic device which sets de direction of the main lobe of an antenna array to the automation device.