A new compact reconfigurable frequency measurement device, based on interferometry is presented in this letter. The device combines the advantages of reconfigurability and fractal geometry. The interferometer uses a Wilkinson power divider connected to two microstrip delay lines; one of these corresponds to the second iteration of the Hilbert fractal curve. PIN diode switches are properly placed in the fractal delay line to achieve a 3-bit circuit, which operates in the 2.7-4.5-GHz range. The design and simulations presented are done using a full-wave electromagnetic simulator, and the frequency responses of the circuit are then shown and compared to measured results.
The authors have studied a new way to design IFM (Instantaneous Frequency Measurement) subsystem. The method is based on band-stop filters. The IFM uses rectangular open loop resonators instead of delay lines. The resonance frequency is adjusted by resonator perimeter, that must be half guided wavelength, and also by coupling distance between the resonators and the main transmission line. A LSB (least significant bit) discriminator of an IFM subsystem with resolution of 62.5 MHz is designed. The device has been fabricated on RT6010.2 substrate of thickness h=1.27 mm. A full wave EM simulator is used to obtain the frequency response.
This paper describes a new method of measuring the complex relative permittivity epsiv* of high-loss and low-loss materials up to the L-band in the microwave range, based on the six-port technique. The novel feature of this method is the determination of epsiv* directly from the intersection of three circles in the complex epsiv*-plane. This implies that neither liquids nor granulated materials are used as calibration standards; instead, conventional loads are employed. Furthermore, the ambiguity usually found in the phase of S 21 and reported in several methods is completely eliminated by the already consolidated six-port technique. Measured results are here presented for a high-loss material
1 December 2021 in Journal of Microwaves, Optoelectronics and Electromagnetic Applications
This work presents an RFSS with two discrete states, corresponding to a pass‐band or stop‐band response depending on PIN diode biasing. The RFSS behaves as an array of cross dipole elements when all diodes are in the OFF‐state and as a grid when the diodes are in the ON‐state. The cross dipole patch array has a stop‐band filter response and the grid behaves as a pass‐band filter at the design frequency of 1.6 GHz. Simulation and measurements of insertion loss are presented, demonstrating the switchable band‐pass to band‐stop response.