An experiment to investigate the potential of a laser-induced plasma method for determining concrete compressive strength was conducted by focusing a Nd:YAG laser on concrete samples with different degrees of compressive strength. This technique was developed in light of the role of the shock wave in the generation of a laser-induced plasma. It was found that the speed of the shock front depends on the hardness of the sample. It was also found that a positive relationship exists between the speed of the shock front and the ionization rate of the ablated atoms. Hence, the ratio of the intensity between the Ca(II) 396.8 nm and Ca(I) 422.6 nm emission lines detected from the laser-induced plasma can be used to examine the hardness of the material. In fact, it was observed that the ratio changes with respect to the change in the concrete compressive strength. The findings also show that the ratio increases with time after the cement is mixed with water.

Hydrogen emission in laser plasma has been studied by focusing a TEA CO₂ laser and Nd‐YAG lasers on various types of samples, such as glass, quartz, and zircaloy pipes doped with hydrogen. It was found that H_α emission with a narrow spectral width occurs with high efficiency when the laser plasma is produced in low‐pressure host gas. In contrast, the conventional well‐known laser‐induced breakdown spectroscopy (LIBS), which operates at atmospheric air pressure, cannot be applied for the analysis of hydrogen as impurity. The specific characteristic of hydrogen emission in low‐pressure plasma is interpreted on the basis of our shock wave model, taking account of the fact that the hydrogen mass is extremely light compared to that of the host target. Another experimental study on gas analysis was conducted using an Nd‐YAG laser and helium host gas at atmospheric pressure on a sample of mixed water (H₂O) and heavy water (D₂O) in vapor form. It was shown that completely resolved hydrogen (H_α) and deuterium (D_α) emission lines that are separated by only 0.179 nm could be obtained at a properly delayed detection time when the charged particles responsible for the strong Stark broadening effect in the plasma have mostly disappeared. It is argued that a helium metastable excited state plays the important role in the hydrogen excitation process.

The use of polymeric material in heavy metal removal from wastewater is trending. Heavy metal removal from wastewater of the industrial process is of utmost importance in green/sustainable manufacturing. Production of absorbent materials from a natural source for industrial wastewater has been on the increase. In this research, polyurethane foam (PUF), an adsorbent used by industries to adsorb heavy metal from wastewater, was prepared from a renewable source. Castor oil-based polyurethane foam (COPUF) was produced and modified for improved adsorption performance using fillers, analyzed with laser-induced breakdown spectroscopy (LIBS). The fillers (zeolite, bentonite, and activated carbon) were added to the COPUF matrix allowing the modification on its surface morphology and charge. The materials were characterized using Fourier-transform infrared (FTIR), scanning electron microscopy (SEM), and thermal gravimetry analysis (TGA), while their adsorption performance was studied by comparing the LIBS spectra. The bentonite-modified COPUF (B/COPUF) gave the highest value of the normalized Pb I (405.7 nm) line intensity (2.3), followed by zeolite-modified COPUF (Z/COPUF) (1.9), and activated carbon-modified COPUF (AC/COPUF) (0.2), which indicates the adsorption performance of Pb²⁺ on the respective materials. The heavy metal ions’ adsorption on the B/COPUF dominantly resulted from the electrostatic attraction. This study demonstrated the potential use of B/COPUF in adsorption and LIBS quantitative analysis of aqueous heavy metal ions.