Ahmad Alshwawra

Dr. Ahmad Alshwawra

School of Applied Technical Sciences, German Jordanian University, Amman, Al ‘Āşimah, Jordan
orcid

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
14 November 2019 in Energy, Sustainability and Society
Verified
Journal Article
Open access
PDF file
AAAhmad Al-Muhtady
Ahmad Al-Muhtady
Ahmad AlshwawraAhmad Alshwawra
Ahmad Alshwawra
MAMarwa Alfaouri
Marwa Alfaouri
WAWael Al-Kouz
Wael Al-Kouz
IAIsmael Al-Hinti
Ismael Al-Hinti
Background: Efficient production and reliable availability of electricity requires comprehensive understanding of load demand trends to plan and match production with consumption. Although electricity demand depends on a combination of cultural and economic conditions, weather conditions remain as the major driver. With increased capabilities of accurate predictions of weather, the importance of investigating and quantifying its impact on electricity demand becomes obvious. The electrical system in Jordan has been facing several challenges including the failure to respond to increased demands induced by extreme temperatures. This paper covers a clear gap in literature through presenting a detailed investigation of the electricity consumption trends and in identifying the susceptibility of these trends to weather. Methods: This study relies on the statistical processing and analysis, through modeling of hourly electricity demands in Jordan in the period of 10 years between 2007 and 2016. Actual weather data was used employing the degree-day approach. The monthly, daily, and hourly seasonal variation indices were determined. Optimally formulated piecewise functions were used to track the thermal comfort zone and rate of increase in electricity demand for temperatures beyond it for each year. Moreover, the elasticity of polynomial functions was adopted to identify saturation points to thermally map the electricity consumption. Results: The developed models successfully described the relationship between the daily electricity demand and the mean daily ambient temperature. The average comfort zone width was 4 °C and the average mean base temperature was 17.9 °C. The sensitivity of electricity demand to both high and low temperatures has increased on average, with 11% and 16.4% to hot and cold weather, respectively. Finally, the electricity demand in cooling was found to saturate at 32.9 °C, whereas it saturates for heating at 4.7 °C. Conclusions: The electricity demand in Jordan observes seasonal trends in a consistent and predictable manner. An optimally formulated piecewise function successfully tracked the thermal comfort zone and the rate of increase in electricity demand for temperatures beyond it for each year of the study period. Finally, saturation heating and cooling temperatures were acquired from the elasticity of the daily electricity demands modeled against daily HDD and CDD.

18 March 2020 in International Journal of Energy Economics and Policy
Verified
Journal Article
Open access
PDF file
Ahmad AlshwawraAhmad Alshwawra
Ahmad Alshwawra
AAAhmad Almuhtady
Ahmad Almuhtady
Impact of Regional Conflicts on Energy Security in Jordan

1 March 2020 in Energy
Verified
Journal Article
Closed access
Jamil Jawdat Al AsfarJamil Jawdat Al Asfar
Jamil Jawdat Al Asfar
Ahmad AlshwawraAhmad Alshwawra
Ahmad Alshwawra
NSNabeel Abu Shaban
Nabeel Abu Shaban
Mohammad AlrbaiMohammad Alrbai
Mohammad Alrbai
BQBashar Qawasmeh
Bashar Qawasmeh
OOOmar Odeh
Omar Odeh

24 December 2019 in International Journal of Engine Research
Verified
Journal Article
Closed access
PDF file
Ahmad AlshwawraAhmad Alshwawra
Ahmad Alshwawra
HPHenning Pasligh
Henning Pasligh
HHHauke Hansen
Hauke Hansen
FDFriedrich Dinkelacker
Friedrich Dinkelacker
Increasing the efficiency of internal combustion engines is of major interest for reduced greenhouse gas emission. A significant improvement potential is given with the reduction of friction losses. Here, especially the friction between the piston ring and the cylinder liner is of interest. This article describes a study with the target to enhance the piston ring–cylinder liner conformation through increasing the roundness of the deformed liner during the warm operation state. The approach is based on the assumption that a non-circular liner in the cold state can deform due to thermal and mechanical stresses toward a circular shape under typical hot operation conditions. To test this hypothesis, a computational model for a gasoline engine was built and simulated using advanced finite element methods. The simulation describes the deformation process of the liner from the thermal and mechanical stresses. First, the deformation of a circular liner is simulated, showing asymmetric deformations of up to 30 µm in the warm state for the cylinder positioned at the end of the four-cylinder bank. As experimental data are readily available, a comparison was possible, showing good agreement. Then, three liner configurations with non-circular shape in the cold stage are investigated. For an elliptically shaped configuration, a nearly circular-shaped liner is reached under typical operation conditions. This numerical approach shows the potential for reduced friction of the piston–liner arrangement within internal combustion engines. The planned next step is the extension of this method to three-dimensional shape aspects and the application to the geometry of our test engine of our lab where friction can be measured in detail with a floating-liner measurement system.

27 May 2020 in Applied Sciences
Verified
Journal Article
Open access
PDF file
Ahmad AlshwawraAhmad Alshwawra
Ahmad Alshwawra
FPFlorian Pohlmann-Tasche
Florian Pohlmann-Tasche
FSFrederik Stelljes
Frederik Stelljes
FDFriedrich Dinkelacker
Friedrich Dinkelacker
Reducing friction is an important aspect to increase the efficiency of internal combustion engines (ICE). The majority of frictional losses in engines are related to both the piston skirt and piston ring–cylinder liner (PRCL) arrangement. We studied the enhancement of the conformation of the PRCL arrangement based on the assumption that a suitable conical liner in its cold state may deform into a liner with nearly straight parallel walls in the fired state due to the impact of mechanical and thermal stresses. Combining the initially conical shape with a noncircular cross section will bring the liner even closer to the perfect cylindrical shape in the fired state. Hence, a significant friction reduction can be expected. For the investigation, the numerical method was first developed to simulate the liner deformation with advanced finite element methods. This was validated with given experimental data of the deformation for a gasoline engine in its fired state. In the next step, initially conically and/or elliptically shaped liners were investigated for their deformation between the cold and fired state. It was found that, for liners being both conical and elliptical in their cold state, a significant increase of straightness, parallelism, and roundness was reached in the fired state. The combined elliptical-conical liner led to a reduced straightness error by more than 50% compared to the cylindrical liner. The parallelism error was reduced by 60% to 70% and the roundness error was reduced between 70% and 80% at different liner positions. These numerical results show interesting potential for the friction reduction in the piston-liner arrangement within internal combustion engines.

4 May 2023 in Heliyon
Verified
Journal Article
Open access
Ahmad AlshwawraAhmad Alshwawra
Ahmad Alshwawra
AAAhmad Almuhtady
Ahmad Almuhtady
ASAhmad Sakhrieh
Ahmad Sakhrieh
Jordan energy sector is characterized by the high dependency on imported energy and high growth rate of energy demands. The location of Jordan in a conflict hot spot makes the energy security of high interest for the Jordanian policy maker. This article investigates the impact of regional conflicts on Jordanian energy sector and tracks the development of electricity system security before and after the first wave of Arab uprising and the turmoil associated with it. An electricity sector security framework consisting of eleven indices is built based on Stirling four properties of energy security, which are durability, stability, robustness and resilience. The framework is used to compare the security of the system in 2018 with 2010. This article argues that the development in the security during the study period is a response of the Arab uprising based on authoritarian learning phenomena. The results are validated by comparing the expected generation costs and CO2 emissions based on actual development with development scenarios found in literature. A forecasting model is reproduced for this purpose. The results of the forecasting model support the conclusion reached by the security framework. This is due to the responsive policies followed by the Jordanian government and the grants given by Gulf countries to enhance Jordan’s stability. It was concluded that even a specific conflict can have negative impacts on the energy sector in a neighboring country in short terms, it can have positive impacts in medium and long term if a rational and sustainable response plan is adopted.