Lu Wang

Mr. Lu Wang


Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 June 2020 in Materials
Verified
Journal Article
Open access
PDF file
LWLu Wang
Lu Wang
XYXiaofang Yang
Xiaofang Yang
Joseph D RobsonJoseph D Robson
Joseph D Robson
RSRobert Sanders
Robert Sanders
QLQing Liu
Qing Liu
The influence of heating rate on the microstructural evolution of a cold-rolled AA7075 alloy sheet during solution heat treatment was examined using electrical conductivity, scanning electron microscopy, X-ray diffraction, transmission electron microscopy and electron backscatter diffraction. The results indicate that the dissolution of soluble phases takes place during the heating process. The heating rates affect the dissolution process of soluble phases, and these phases completely dissolve into matrix after solution treatment. Recrystallized and elongated grains are produced after solution treatment by both fast and slow heating rates, while the grains of the rapidly heated sample are much finer. The elongated grains are attributed to the difference in the pinning pressure of boundary migration between the rolling and normal directions. The {111} texture, as well as typical recrystallization textures, were found in both fast and slowly heated samples after solution treatment, but the textures, especially the {111} component in the slow-heated sample, are much stronger, leading to an anisotropy in the tensile properties after artificial aging.

14 September 2021 in Materials
Verified
Journal Article
Open access
PDF file
SXShihua Xiang
Shihua Xiang
XYXiaofang Yang
Xiaofang Yang
YLYanxiang Liang
Yanxiang Liang
LWLu Wang
Lu Wang
Multifilamentary microcomposite copper-niobium (Cu-Nb) wires were fabricated by a series of accumulative drawing and bonding steps (ADB). The texture of the Cu matrix in these wires was studied using electron backscattered diffraction (EBSD) and transmission electron microscopy (TEM). Dynamic recrystallization during cold drawing caused a weakening of the texture in the micron-scale Cu matrix at high values of true strain. A sharp texture was observed in the nano-scale Cu matrix due to the suppression of dynamic recrystallization. The grain size was reduced by the higher level of dynamic recrystallization at high strains. The relation between the nanoindentation behavior of the different Cu matrix and the grain sizes, Cu-Nb interface, and texture was established.