Multifilamentary microcomposite copper-niobium (Cu-Nb) wires were fabricated by a series of accumulative drawing and bonding steps (ADB). The texture of the Cu matrix in these wires was studied using electron backscattered diffraction (EBSD) and transmission electron microscopy (TEM). Dynamic recrystallization during cold drawing caused a weakening of the texture in the micron-scale Cu matrix at high values of true strain. A sharp texture was observed in the nano-scale Cu matrix due to the suppression of dynamic recrystallization. The grain size was reduced by the higher level of dynamic recrystallization at high strains. The relation between the nanoindentation behavior of the different Cu matrix and the grain sizes, Cu-Nb interface, and texture was established.
The effects of 0.1 wt.% Sc and 0.1 wt.% Zr addition in AA5182 on microstructure and mechanical properties were investigated. Results show that Al3(ScxZr1−x) dispersoids formed in AA5182. Observation of ingots microstructures showed that the grain size of 5182-Sc-Zr alloy was 56% lower than that of based AA5182. Isothermal annealing between 230 °C and 500 °C for 2 h was performed to study the recrystallization, tensile properties and dispersoid coarsening. The recrystallization was inhibited by the dispersoids, and the alloy microstructure remained deformed after annealing. Al3(ScxZr1−x) in AA5182 was stable when annealing below 400 °C, while parts of dispersoids coarsened significantly when heating at 500 °C. The addition of Sc and Zr allowed YS of 5182 alloy to achieve 247.8 MPa, which is 100 MPa higher than the corresponding AA5182. The contributions of Orowan strengthening and grain boundary strengthening were obtained by calculation.
Artificial neural networks (ANNs) were established for the homogenization and recrystallization heat treatment processes of 5182-Sc-Zr alloy. Microhardness and conductivity testing were utilized to determine the precipitation state of Al3(ScxZr1−x) dispersoids during the homogenization treatment, while electron backscatter diffraction (EBSD) and transmission electron microscopy (TEM) were used to observe the microstructure evolution of the alloy. Tensile experiments were performed to test the mechanical properties of the alloy after recrystallization annealing. The two-stage homogenization parameters were determined by studying the changes in microhardness and electrical conductivity of 5182-Sc-Zr alloy after homogenization with the assistance of artificial neural networks: the first-stage homogenization at 275 °C for 20 h and the second-stage homogenization at 440 °C for 12 h. The dispersoids had entirely precipitated after homogenization, and the alloy segregation had improved. A high-accuracy prediction model, incorporating multiple influencing factors through artificial neural networks, was successfully established to predict the mechanical properties of the 5182-Sc-Zr alloy after annealing. Based on the atomic plane spacing in HRTEM, it was determined that the Al3(ScxZr1−x) dispersoids and the Al matrix maintained a good coherence relationship after annealing at 400 °C.