Cannabis sativa L. seeds have been an important source of protein, oil, and dietary fiber for human and animals. Currently, there is a growing interest in the commercial products of these seeds, which are recognized as a legitimate source of medicaments, cosmeceuticals, and nutraceuticals. The objective of this study was to investigate the nutritional, phytochemical composition, and antioxidant properties of seeds from seven hemp cultivars grown in Greece for three consecutive years. All the measured parameters strongly varied under the influence of growing year and genotype. In particular, protein, oil, and carbohydrates’ content of hemp seeds as well as fatty acids’ composition were mainly affected by genotype, whereas the growing year had a major effect on phytochemical components and antioxidant activity, which was determined by the 2,2′-azino-bis (3-ethylbenzthiazoline sulfonate) (ABTS) and ferric-reducing antioxidant power (FRAP) assays. Moreover, a predominant effect of the year was observed for phenolic profiles as determined by high-performance liquid chromatography and total carotenoids’ content. This study suggests that hemp seeds could be a promising food crop as a result of their high nutritive traits and antioxidant potential. A comparison of the studied cultivars, showed that Finola seeds had the highest oil and protein contents and, thus, appeared to be the most promising cultivar for cultivation in Greece.

Plant solid residues obtained from the essential oil industry represent a rich source of phenolic compounds with bioactive properties to be used in the food and pharmaceutical industries. A selective and sensitive liquid chromatography-mass spectrometry (LC-MS) method was developed for the simultaneous determination of phenolic compounds in solid residues of the Lamiaceae family plants. A total of 48 compounds can be separated within 35 min by using the Poroshell-120 EC-C₁₈ column, and a gradient mobile phase of 0.1% formic acid and acetonitrile with flow rate of 0.5 mL/min; salicylic acid was used as internal standard. The calibration curves showed good linearity in the tested concentration range for each analyte (R² > 0.9921), while recoveries ranged from 70.1% to 115.0% with an intra-day and inter-day precision of less than 6.63% and 15.00%, respectively. Based on the retention behavior, as well as absorption and mass spectra, 17 phenolic acids, 19 flavonoids and 2 phenolic diterpenes were identified and quantified in the solid residues obtained by distillation of six aromatic plants: oregano, rosemary, sage, satureja, lemon balm, and spearmint. The method constitutes an accurate analytical and quality control tool for the simultaneous quantitation of phenolics present in solid waste residues from the essential oil industry.

The objective of this study was to evaluate the effects of different stabilization treatments—namely, dry-heating, infrared-radiation, and microwave-heating—on the nutritional, antinutritional, functional, and bioactivity attributes of rice bran (RB). Among the heating treatments, infrared-radiation exerted the strongest inactivation, resulting in 34.7% residual lipase activity. All the stabilization methods were found to be effective in the reduction of antinutrients, including phytates, oxalate, saponins, and trypsin inhibitors. No adverse effect of stabilization was noted on chemical composition and fatty acid profile of RB. Instead, stabilization by all heat treatments caused a significant decrease of vitamin E and total phenolics content in RB; the same trend was observed for the antioxidant activity as evaluated by the DPPH test. The antioxidant activity, as evaluated by ABTS and FRAP tests, and water absorption capacity were improved by the stabilization of RB, whereas the oil absorption capacity and emulsifying properties decreased. Microwave-heating enhanced the foaming properties, whereas infrared-radiation improved the water solubility index and swelling power of RB. Consequently, treatment of RB with infrared-radiation has a potential for industrialization to inactivate the lipase and improve some functional properties of this material for uses as a nutraceutical ingredient in food and cosmetic products.

Rice by-products are extensively abundant agricultural wastes from the rice industry. This study was designed to optimize experimental conditions for maximum recovery of free and bound phenolic compounds from rice by-products. Optimized conditions were determined using response surface methodology based on total phenolic content (TPC), ABTS radical scavenging activity and ferric reducing power (FRAP). A Box-Behnken design was used to investigate the effects of ethanol concentration, extraction time and temperature, and NaOH concentration, hydrolysis time and temperature for free and bound fractions, respectively. The optimal conditions for the free phenolics were 41–56%, 40 °C, 10 min, whereas for bound phenolics were 2.5–3.6 M, 80 °C, 120 min. Under these conditions free TPC, ABTS and FRAP values in the bran were approximately 2-times higher than in the husk. However, bound TPC and FRAP values in the husk were 1.9- and 1.2-times higher than those in the bran, respectively, while bran fraction observed the highest ABTS value. Ferulic acid was most evident in the bran, whereas p-coumaric acid was mostly found in the husk. Findings from this study demonstrates that rice by-products could be exploited as valuable sources of bioactive components that could be used as ingredients of functional food and nutraceuticals.

Farmers’ interest in renewable raw materials such as hemp (Cannabis sativa L.) fibres has recently increased, but hemp productivity is strongly affected by genotype and environment conditions. A 3-year field experiment was conducted under Mediterranean environment in northern Greece to evaluate the productivity (regarding fibres and seeds) of six monoecious hemp varieties. The vars. Futura 75 and Bialobrzeskie provided the greatest (p < 0.01) fibre productivity (4.57 and 4.27 t ha⁻¹, respectively), which were 77.1% and 65.5%, respectively, greater than that of the least productive var. Fedora 17. However, the vars. Santhica 27, Tygra and Bialobrzeskie provided the highest (p < 0.05) seed yield (2.7, 2.9 and 2.6 t ha⁻¹, respectively), which were 28.6%, 38.1% and 23.8%, respectively, greater than that of the least productive var. Futura 75. Hemp fibre yield was strongly positively correlated with total biomass (R² = 0.8612) and stem biomass yield (R² = 0.9742), while it was inversely correlated with fibre strength (R² = 0.424). Hemp seed yield was not correlated with the hemp plant density, height, total biomass or stem biomass yield. The six hemp genotypes evaluated in the study had Δ9-tetrahydrocannabinol (THC) content lower than 0.2% satisfying the European legislation requirements for industrial hemp varieties. The results of the study indicated that, under Mediterranean conditions (northern Greece), the var. Bialobrzeskie showed high productivity, as averaged across years, for both fibres and seeds. This result is very helpful for farmers which should prefer hemp varieties of dual-purpose production (stems and inflorescences or stems and seeds) adapted best to their local environment.