The Hall thruster is a high-efficiency spacecraft propulsion device that utilizes plasma to generate thrust. The most common variant of the Hall thruster is the stationary plasma thruster (SPT). Erosion of the SPT discharge chamber wall by plasma sputtering degrades thruster performance and ultimately ends thruster life. Many efforts over the past few decades have endeavored to understand wall erosion so that novel thrusters can be designed to operate for the thousands of hours required by many missions. However, due to the challenges presented by the plasma and material physics associated with erosion, a complete understanding has thus far eluded researchers. Sputtering rates are not well quantified, erosion features remain unexplained, and computational models are not yet predictive. This article reviews the physics of plasma-induced SPT erosion, highlights important experimental findings, provides an overview of modeling efforts, and discusses erosion mitigation strategies.
Terahertz time-domain spectroscopy (THz-TDS) is an optical diagnostic used to noninvasively measure plasma electron density and collision frequency. Conventional methods for analyzing THz-TDS plasma diagnostic data often do not account for measurement artifacts and do not quantify parameter uncertainties. We introduce a novel Bayesian framework that overcomes these deficiencies. The framework enables computation of both the density and collision frequency, compensates for artifacts produced by refraction and delay line errors, and quantifies parameter uncertainties caused by noise and imprecise knowledge of unmeasured plasma properties. We demonstrate the framework with sample measurements of a radio frequency inductively-coupled plasma discharge.
We measured the Hugoniot, Hugoniot elastic limit (HEL), and spallation strength of laser powder bed fusion (LPBF) AlSi10Mg via uniaxial plate-impact experiments to stresses greater than 13 GPa. Despite its complex anisotropic microstructure, the LPBF AlSi10Mg did not exhibit significant orientation dependence or sample-to-sample variability in these measured quantities. We found that the Hugoniot response of the LPBF AlSi10Mg is similar to that of other Al-based alloys and is well approximated by a linear relationship: . Additionally, the measured HELs ranged from 0.25 to 0.30 GPa and spallation strengths ranged from 1.16 to 1.45 GPa, consistent with values reported in other studies of LPBF AlSi10Mg and Al-based alloys. Strain-rate and stress dependence of the spallation strength were also observed.
1 July 2021 in Plasma Sources Science and Technology
We experimentally demonstrate the capability of terahertz time-domain spectroscopy (THz-TDS) to noninvasively measure the electron density and collision frequency of plasma bounded and optically shielded by Hall thruster wall material. This paper augments the standard THz-TDS plasma diagnostic theory to account for plasma boundaries, presents THz optical property measurements of three different wall materials (grades M, M26, and HP boron nitride composite), and provides electron density and collision frequency measurements of an inductively coupled plasma bounded and optically shielded by each wall material. We find that the electron density measurement capability is weakly impacted by the boundaries, whereas the electron collision frequency measurement capability is strongly reduced by the boundaries. The bounded plasma electron density trends deviate substantially from those of the unbounded plasma.
We uniaxially and shocklessly compressed an additively manufactured aluminum alloy, laser powder bed fusion (LPBF) AlSi10Mg, to peak stresses ranging from 4.4 to 14.8 GPa at peak strain rates on the order of via a series of magnetic loading experiments to measure the principal isentrope, yield strength, and shear modulus as a function of material orientation and applied stress. We did not observe significant anisotropy in any of the measured quantities. We found that the principal isentrope, within the uncertainty and up to our peak stress, overlaps the material’s Hugoniot. We measured yield strengths and shear moduli ranging from 0.28 to 0.81 GPa and 36 to 52 GPa, respectively. Our results indicate that LPBF AlSi10Mg behaves similarly to wrought Al alloys under quasi-isentropic compression.