This paper develops an ultra-low power asynchronous circuit design methodology, called Multi-Threshold NULL Convention Logic (MTNCL), also known as Sleep Convention Logic (SCL), which combines Multi-Threshold CMOS (MTCMOS) with NULL Convention Logic (NCL), to yield significant power reduction without any of the drawbacks of applying MTCMOS to synchronous circuits. In contrast to other power reduction techniques that usually result in large area overhead, MTNCL circuits are actually smaller than their original NCL versions. MTNCL utilizes high-V_t transistors to gate power and ground of a low-V_t logic block to provide for both fast switching and very low leakage power when idle. To demonstrate the advantages of MTNCL, a number of 32-bit IEEE single-precision floating-point co-processors were designed for comparison using the 1.2 V IBM 8RF-LM 130 nm CMOS process: original NCL, MTNCL with just combinational logic (C/L) slept, Bit-Wise MTNCL (BWMTNCL), MTNCL with C/L and completion logic slept, MTNCL with C/L, completion logic, and registers slept, MTNCL with Safe Sleep architecture, and synchronous MTCMOS. These designs are compared in terms of throughput, area, dynamic energy, and idle power, showing the tradeoffs between the various MTNCL architectures, and that the best MTNCL design is much better than the original NCL design in all aspects, and much better than the synchronous MTCMOS design in terms of area, energy per operation, and idle power, although the synchronous design can operate faster.

As digital circuit design continues to evolve due to progress of semiconductor processes well into the sub 100 nm range, clocked architectures face limitations in a number of cases where clockless asynchronous architectures generate less noise and produce less electro-magnetic interference (EMI). This paper develops the Delay-Insensitive Ternary Logic (DITL) asynchronous design paradigm that combines design aspects of similar dual-rail asynchronous paradigms and Boolean logic to create a single wire per bit, three voltage signaling and logic scheme. DITL is compared with other delay insensitive paradigms, such as Pre-Charge Half-Buffers (PCHB) and NULL Convention Logic (NCL) on which it is based. An application of DITL is discussed in designing secure digital circuits resistant to side channel attacks based on measurement of timing, power, and EMI signatures. A Secure DITL Adder circuit is designed at the transistor level, and several variance parameters are measured to validate the efficiency of DITL in resisting side channel attacks. The DITL design methodology is then applied to design a secure 8051 ALU.