Biological metal leaching is a technology used in the mining and biohydrometallurgy industries where microorganisms mediate the dissolution of metals and semi-metals from mineral ores and concentrates. The technology also has great potential for various types of metal-rich waste. In this study, bioleaching was used for sludge from water treatment. In addition to checking the applicability of the process to such a substrate, the influence of experimental conditions on the effectiveness of bioleaching of metals with sludge from water treatment was also determined, including sample acidification, addition of elemental sulfur, incubation temperature, and Acidithiobacillus thiooxidans-isolated strain. The measurement of metal concentration and, on this basis, the determination of bioleaching efficiency, as well as pH and oxygen redox potential (ORP), was carried out during the experiment at the following time intervals: 3, 6, 9, 12 days. After the experiment was completed, a mass balance was also prepared. After the experiment, high efficiency of the process was obtained for the tested substrate. The effectiveness of the process for most metals was high (Ca 96.8%, Cr 92.6%, Cu 80.6%, Fe 95.6%, Mg 91%, Mn 99.5%, Ni 89.7%, Pb 99.5%, Zn 93%). Only lower values were obtained for Al (58.6%) and Cd (68.4%).

Among the methods used to remove metals and their compounds from landfill leachates with low application costs and high efficiency are bioleaching and biosorption. The most effective bacteria used in the metal removal process are Acidithiobacillus ferrooxidans and Acidithiobacillus thiooxidans. The aim of the study was to determine the usefulness of the A. ferrooxidans and A. thiooxidans population in removing heavy metals from landfill leachate. In addition, development opportunities for bacterial population using landfill leachate as growth medium were identified. The substrate for the research was the raw leachate before the reverse osmosis process. In order to increase the efficiency of trace elements removal and recovery from leachate, variable combinations have been used which differ by the addition of sulfuric acid, A. ferrooxidans culture, A. thiooxidans culture, mixed culture containing populations of both bacteria, and elemental sulfur. Based on the research, it was found that the removal of heavy metals from leachate was a selective process. High bioleaching efficiency, from 80% to 90%, was obtained for all metals for which the sample acidification or sulfur addition was used. The simultaneous combination of both these additives turned out to be the most advantageous. The A. thiooxidans culture was the most effective in bioleaching reverse osmosis effluents. For the A. ferrooxidans culture used, much lower efficiencies were obtained, while by contrast, the use of mixed culture of two bacterium species had no significant effect.

Sludge dewatering is a key element in sludge’s processing and management. Solid-phase separation, sludge volume reduction and the separation of a high-quality supernatant are the main tasks of the dewatering devices. The effectiveness of this task, in turn, results from the selection of the dewatering method and conditioning of the sludge before dewatering. The aim of the research was to determine the influence of conditioning substances (polyelectrolyte, fly ash and zeolite) on the efficiency of dewatering at variable filtration pressure. The use of polyelectrolyte in sludge conditioning was a solution that increased the efficiency of the filtration process. On the contrary, the use of structure-forming substances (fly ash and zeolite) slows the process but reduces the hydration of the filter cake. The same trends were obtained in dual conditioning combining dosing of polyelectrolyte and ash or zeolite. It was also shown that the dewatering efficiency of conditioned sludge with these two different substances (ash and zeolite) was the same. The use of zeolite in independent or dual conditioning was important for the quality of the supernatant.